(1)  
GENERAL

(a)  
This section gives instructions for the disassembly of the Center Console.

(b)  
Disassemble the unit only when repair is necessary and only to the extend necessary for repair.

(c)  
Make a visual inspection of the Center Console before the disassembly as described in CHECK.

(d)  
Make a test of the Center Console as described in TESTING AND FAULT ISOLATION.

(e)  
For numbers in parenthesis which follow item names in the procedures refer to the figures and item numbers in the ILLUSTRATED PARTS LIST.

(2)  
LIST OF EQUIPMENT
Not applicable

(3)  
DISASSEMBLY OF THE CENTER CONSOLE
EFFECT: BA730020100

(a)  Disassembly of the Standard Center Console (Refer to IPL figure 4) 1 Remove the access cover assy (10), (20). 2 Remove the side cover assy (30), (40). 3 Open the life vest door assy (50). 4 Remove the screws (90), the lower life vest bracket (80) and the life vest door assy (50). 5 Remove the screws (70) and the front cover assy (60). 6 Remove the life vest liner (100), (110). 7
Remove the screws (130), (140), the washers (150) and the command center (120). 8
Remove the screws (170) and the stowage
bin assy (180).
9 Remove the screws (170) and the rear cover assy (160).

Recaro Aircraft Seating GmbH & Co. KG, Daimlerstrasse 21, D.74523 Schw.bisch Hall
COMPONENT MAINTENANCE MANUAL . 6510A TYPE
654 SERIES

10 Remove the screws (210), the cosmetic backing plate (200) and the bumper strip (190). 11 Remove the screws (170), the top front cover assy (240) and the manual release cover
assy (250), (260). 12 Remove the hand rail (220). 13 Remove the screws (300), (320), the hinge cover assy (270), (280) and the arm rest assy
(290), (310). 14 Remove the screws (340) and the elbow cavity assy (330), (350). 15 Remove the nuts (410), the washers (390), (400), the mushroom screws (380) and the
UPCU cradle assy (360), (370). 16 Remove the screws (230) and the cocktail tray assy (420). 17 Remove the screws (460) and the audio jack support assy (450), (470). 18 Remove the screws (490), (510), the cartridge table assy (480), (500) and the rhino body
assy (430), (440). 19 Remove the screw (170) and the drip shield (520). 20 Remove the nuts (560), the washers (550), the screws (540), (570) and the privacy
divider assy (530) from the panel assy (590).
21 Remove the cable guide (580).

(b)  DISASSEMBLY OF THE TABLE CARTRIDGE ASSEMBLY (REFER TO IPL FIGURE 4A) 1 Remove the set screws (170), the tray table shaft (20) and the arm table assy (10). 2 Disassembly of the Arm Table Assy
a  Remove the screws (70) and the table arm (30).

b  Remove the screws (40), the upper lever arm stop (50) and the dowel pin (60) from
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：COMPONENT MAINTENANCE MANUAL WITH ILLUSTRATED PARTS LIST B757−200 PASSENGER SEAT 乘客座椅(30)