(d)
Nuts (38)
(e)
Cotter Pins (39)
32-22-00
ALL ú ú 04 Page 514 ú Sep 28/01
A
757 MAINTENANCE MANUAL
G. Put the Airplane Back to Its Usual Condition S 585-050
(1) Lower the airplane and remove the jacks (AMM 07-11-02/201).
S 095-089
WARNING:_______OBEY THE REMOVAL PROCEDURE FOR THE DOOR LOCKS. THE DOORS OPEN AND CLOSE QUICKLY. THE MOVEMENT OF THE DOORS CAN CAUSE INJURIES TO PERSONS AND DAMAGE TO EQUIPMENT.
(2)
Remove the door locks and close the doors (AMM 32-00-15/201). S 865-052
(3)
Remove the power from the left hydraulic system (AMM 29-11-00/201). S 865-053
(4)
Remove the electrical power if it is not necessary
(AMM 24-22-00/201).
32-22-00
ALL ú ú 09 Page 515 ú Sep 28/01
A
757 MAINTENANCE MANUAL
NOSE GEAR FORWARD DOOR - REMOVAL/INSTALLATION
_____________________________________________
1. General
_______
A. This procedure contains two tasks. The first task removes the forward doors of the nose landing gear. The second task installs the forward doors of the nose landing gear.
TASK 32-22-01-004-001
2. Remove the Forward Door of the Nose Landing Gear (Fig. 401)
________________________________________________
A. References
(1)
32-00-15/201, Landing Gear Door Locks
(2)
32-00-20/201, Landing Gear Downlocks
B.
Access
(1)
Location Zones
711 Nose Landing Gear (NLG)
713/714 Forward NLG Doors
715/716 Aft NLG Doors
730/740 Main Landing Gear and Doors
C.
Prepare for the Removal of the Forward Doors
S 494-002
(1) Make sure the downlocks are installed on the nose and main landing gear (Ref 32-00-20).
S 494-015
ú WARNING:_______USE THE PROCEDURE IN AMM 32-00-15 TO INSTALL THE DOOR LOCKS. THE DOORS OPEN AND CLOSE QUICKLY AND CAN CAUSE INJURY TO PERSONS OR DAMAGE TO EQUIPMENT.
(2)
Open the doors for the landing gear and install the door locks (Ref 32-00-15).
D.
Remove the Forward Door
S 014-004
(1) Remove the bolts (4 and 8) to disconnect the bonding jumpers from the door hinges.
32-22-01
ALL ú ú 01.1 Page 401 ú Sep 28/02
A
757
MAINTENANCE MANUAL
Forward Door Installation for the Nose Landing Gear
Figure 401 (Sheet 1)
32-22-01
ALL ú ú 01 Page 402 ú Mar 20/95
A
757
MAINTENANCE MANUAL
FITTING FOR THE FITTING FOR THE
HINGE SUPPORT HINGE SUPPORT
1.
BOLT 13. BOLT
2.
NUT
ASSEMBLY ASSEMBLY
3. WASHER
DOOR HINGE
DOOR HINGE
16. BUSHING
Forward Door Installation for the Nose Landing Gear
Figure 401 (Sheet 2)
32-22-01
ALL ú ú 01 Page 403 ú Mar 20/95
A
757
MAINTENANCE MANUAL
S 014-005
(2)
Remove the bolt (17) to disconnect the operating rod for the door from the attach fitting.
S 024-006
(3)
Hold the door.
(a)
Remove the bolts (1 and 13) to disconnect the door hinges from the support fittings on the wall of the wheel well.
TASK 32-22-01-404-007
3. Install the Forward Door of the Nose Landing Gear (Fig. 401)
_________________________________________________
A. Consumable Materials
(1)
D00633 Grease - BMS 3-33 (Recommended)
(2)
D00013 Grease - MIL-G-23827 (Alternative)
B.
Parts
~.............................................................................. | AMM | | AIPC | ................. ............................ | FIG | ITEM | NOMENCLATURE | SUBJECT |FIG | ITEM | ................................................................................ | 401 | 1 | Bolt Assembly | 32-22-01 | 01 | 7 | | | 2 | Nut | | | 25 | | | 3 | Washer | | | 20 | | | 4 | Bolt | | | 17 | | | 5 | Washer | | | 22 | | | 6 | Spacer | | | 38 | | | 7 | Nut | | | 28 | | | 8 | Bolt | | | 17 | | | 9 | Washer | | | 22 | | | 10 | Spacer | | | 38 | | | 11 | Nut | | | 28 | | | 12 | Forward Door | | |40,45 | | | 13 | Bolt Assembly | | | 14 | | | 14 | Washer | | | 20 | | | 15 | Nut | | | 25 | | | 16 | Bushing | | | 35 | | | 17 | Bolt | 32-22-02 | 01 | 5 | | | 18 | Washer | | | 15 | | | 19 | Bushing | | | 30 | | | 20 | Nut | | | 20 | 2......…........…...................................…...........…....….........1
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：757 AMM 飛機維護手冊 起落架 CHAPTER 32 - LANDING GEAR 2(24)
