B. Install the Engine Control Assembly
Detail Steps/Work Items Key Items/References
(1) Make sure that there are no loose items, specially in the center console.
(2) Move the engine control assembly onto the center console and support it in a position where you can install the control cables.
(3) Connect these control cables to the engine control assembly: S Propeller control cable. S Throttle control cable. S Mixture control cable. S Parking brake control cable. S Cabin heat distribution control cable. S Cabin heat control cable. Refer to Section 61-20. Refer to Section 76-00. Refer to Section 76-00. Refer to Section 32-40. Refer to Section 21-00. Refer to Section 21-00.
Page 202 Doc # 6.02.01 09 Jan 2003 Rev. 4
31-10-00
Indicating Systems
AMM
DA 40 Series
Detail Steps/Work Items Key Items/References
(4) Pull the throttle friction control knob clear and lower the engine control assembly into the center console.
(5) Align the throttle friction control knob to screw onto the friction shaft in the engine control assembly. Do not tighten.
(6) Install the engine control assembly front cover plate: S Move the cover plate into position on the engine control assembly. S Install the 2 hex-headed bolts which attach the cover plate and engine control assembly. Do not tighten.
(7) Install the engine control assembly rear cover plate: S Move the cover plate into position on the engine control assembly. S Install the 4 cross-head screws which attach the rear cover plate to the control assembly. S Tighten the screws.
(8) Tighten the 2 hex-headed bolts in the front cover plate.
(9) Adjust the throttle friction adjuster to the required friction.
(10) Do a test for correct range, full and free movement of the throttle control system. Refer to the Throttle Control Range of Movement Test in Section 76-00.
(11) Do a test for correct range, full and free movement of the mixture control system. Refer to the Throttle Control Range of Movement Test in Section 76-00.
(12) Do a test for correct range, full and free movement of the propeller control system. Refer to the Throttle Control Range of Movement Test in Section 61-00.
(13) Do an inspection of the control connections which you disconnected. If necessary, for your airworthiness authority, do a second inspection of the controls.
31-10-00
AMM
DA 40 Series
Detail Steps/Work Items Key Items/References
(14) Do a test for correct range, full and free movement of the cabin heat control system. Refer to Section 21-00.
(15) Do a test for correct range, full and free movement of the cabin heat distribution system. Refer to Section 21-00.
(16) Install the knob on the fuel selector valve: S Install the mounting plate. S Push the knob onto the fuel valve selector shaft. S Install the cross-head screw which attaches the knob to the shaft.
31-10-00
Indicating Systems
AMM
% Section 31-11 % Instrument and Control Panels - TAE 125 Diesel Engine % 1. General
% The DA 40 with the TAE 125 Diesel engine installed has these instrument and control panels:
%) An instrument panel. The instrument panel is made in one piece with a shelf. The shelf goes % between the panel and the firewall.
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：鉆石40飛機維護手冊 DA 40 SERIES AMM 3(63)
