%
Doc # 6.02.01 Page 211
Rev. 4 09 Jan 2003
28-21-00
AMM
% 7. Test the Check Valve in the Fuel Return Line
% CAUTION: YOU MUST REPLACE THE CHECK VALVE IF THE TEST FAILS. %
%
%
%
%
%
%
%
%
%
%
%
%
Detail Steps/Work Items Key Items/References
(1) Make sure that the left fuel tank (main tank) is full. (Refer to Section 12-10).
(2) Disconnect the fuel return line from the fuel filter. At the fuel filter, 'out return line' port. Put a cap on the open fuel filter port.
(3) Connect an external fuel pump to the open hose.
(4) Switch the external fuel pump ON. The external fuel pump must NOT draw any fuel.
(5) Switch the external fuel pump OFF.
(6) Disconnect the hose from the external fuel pump.
(7) Re-connect return line to fuel filter.
(8) Bleed the fuel distribution system Refer to Paragraph 8.
% % % 8. Bleed the Fuel Distribution System
%
%
%
%
%
%
%
%
%
%
%
%
%
Detail Steps/Work Items Key Items/References
(1) Disconnect the fuel hose from the intake side of the low-pressure fuel pump. At the upper right side of the engine. Put a cap on the pump intake.
(2) Connect the open fuel hose to an external fuel pump.
(3) Switch the external fuel pump ON until fuel with no air is pumped. Collect the fuel in a suitable container.
(4) Disconnect the fuel hose from the external fuel pump.
(5) Connect the fuel hose to the intake side of the low-pressure fuel pump. At the upper right side of the engine.
%
Page 212 Doc # 6.02.01 09 Jan 2003 Rev. 4
28-21-00
Fuel System
AMM
Section 28-40 % Fuel Quantity Indicating - Lycoming Engine
1. General
% This Section tells you about the fuel quantity indicating system of the DA 40 with the Lycoming engine
% installed. Refer to Section 28-00 for the general data on the fuel system and refer to Section 31-10 for data on replacing the fuel quantity indicator.
2. Description
% A. Standard Tanks
% Figure 1 shows the fuel quantity indication system main components for the Standard Tanks. The fuel quantity indicator is part of the integrated engine indicating system. The inboard fuel tank in each wing has a fuel probe and a fuel sensor. The fuel quantity indicating system cannot be calibrated in service.
Electric cables connect the fuel probes to the I/O board of the integrated engine indicating system. The system displays the fuel quantity on an indicator located in the instrument panel, below the integrated engine indicating display.
Electric cables also connect the fuel sensors to a low fuel caution light in the annunciator panel. Refer to Section 31-50 for more data on the annunciator panel.
Doc # 6.02.01 Page 1
Rev. 4 09 Jan 2003
28-40-00
AMM
% Figure 1: Fuel Quantity Indication System Components, Standard Tanks Installed
Page 2 Doc # 6.02.01 09 Jan 2003 Rev. 4
28-40-00
Fuel System
AMM
% There are two versions of the fuel quantity indicating system for the standard tanks. Version A is % compatible with Version A of the inboard fuel chamber. Version B is compatible with Version B of % the inboard fuel chamber. Refer to Section 28-10 for more data on the fuel storage system. 中國航空網 m.k6050.com 航空翻譯 www.aviation.cn 本文鏈接地址：鉆石40飛機維護手冊 DA 40 SERIES AMM 3(52)
