CHAPTER 02
ORGANIZATION AND HANDLING OF
THE MANUAL
Doc # 6.02.01 Page 1
Rev. 4 09 Jan 2003
02-TITLE
AMM
Intentionally left blank
02-TITLE
Manual Organization
AMM
TABLE OF CONTENTS
CHAPTER 02
ORGANIZATION AND HANDLING OF THE MANUAL
1.
General ..............................................1
2.
Applicability ...........................................1
3.
Revisions.............................................1
4.
Temporary Revisions....................................1
5.
Service Bulletins .......................................2
6.
Service Instructions .....................................3
7.
Abbreviations..........................................4
8.
Conversion Factors and Abbreviations.......................5
9.
Torque Conversion Graphs ...............................7
Doc # 6.02.01 Page 1
Rev. 4 09 Jan 2003
02-CONTENTS
AMM
Intentionally left blank
02-CONTENTS
Manual Organization
AMM
CHAPTER 02
ORGANIZATION AND HANDLING OF THE MANUAL
1. General
For data about a system, look in the list of chapters and find the chapter number. The first page of each chapter after the title page shows the contents.
2. Applicability
Data applicable to a series of airplane is marked with an applicability note. For example: Valid for S/N 10067 thru 10090. This shows that you can use this data for airplane with serial numbers 10067 through 10090 inclusive.
3. Revisions
The manufacturer makes changes to the Airplane Maintenance Manual to show design changes, maintenance procedure changes or other changes. Each group of changes is called a ‘Revision’. A manual revision contains these items: ) The changed pages. ) The reason for the revision. ) Instructions for putting the revision into the Airplane Maintenance Manual.
) A new List of Effective Pages. A vertical bar in the left margin of the page shows the changes. Where a figure is changed, a small hand points to the change if necessary.
4. Temporary Revisions
Temporary revisions correct errors, or they give temporary instructions. The manufacturer sends them to the airplane owners quickly. The manufacturer uses yellow paper for temporary revisions. The manufacturer usually puts the contents of a temporary revision in the next approved revision.
Doc # 6.02.01 Page 1
Rev. 4 09 Jan 2003
02-00-00
AMM
5. Service Bulletins
Service Bulletins get issued when necessary. They give the operator more information on inspections, maintenance, repairs or modifications.
Service Bulletins have 4 categories:
A. Alert Service Bulletins
Alert Service Bulletins are issued if there is an immediate danger (risk of damage or total loss). They are sent immediately by the fastest means to all known addresses of operators and service stations which are affected.
B. Mandatory Service Bulletins
Mandatory Service Bulletins include the description of a problem and the solution. If you do not follow a mandatory Service Bulletin, failures or malfunctions can result during further operation.
You must do the work given in a Mandatory Service Bulletin.
C. Recommended Service Bulletins
Recommended Service Bulletins give data about:
) A minor problem and its correction.
) A better technical design. 中國航空網 m.k6050.com 航空翻譯 www.aviation.cn 本文鏈接地址：鉆石40飛機維護手冊 DA 40 SERIES AMM 1(26)
