S 492-049

 (4)  
Install the safety pin into the inflation cylinder regulator.

 S 492-052
 WARNING: MAKE SURE YOU INSTALL THE SAFETY PINS ON THE CORRECT EMERGENCY
_______ POWER RESERVOIR. THE ACCIDENTAL OPERATION OF THE EMERGENCY POWER RESERVOIR CAN CAUSE INJURY OR DAMAGE.
 (5) Install the safety pins on the correct emergency power reservoir.
 NOTE: The reservoirs for the No. 1 passenger doors are left of
____ the airplane center line above the ceiling between the doors. The reservoir for the right No. 1 door is left of the reservoir for the left No. 1 door. The reservoirs for the No. 2 and 4 passenger doors are above each door.
 S 212-053
 (6)  
Look for damage, corrosion, and unwanted material on the girt bar (1), girt bar sliders, and floor fittings.

 (7)  
Examine the floor fittings for loose screws.

 (8)  
Move the mode selector lever to the ENGAGE position.

 S 212-054
 S 862-055
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 25-66-10
 ALL  ú ú 04 Page 210 ú Sep 28/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
757
MAINTENANCE MANUAL

 S 822-058
 CAUTION:_______ DO NOT TURN THE INTERIOR HANDLE TO THE FULLY UNLATCHED POSITION
 WHILE THE DOOR IS IN THE ENGAGE MODE.  THIS WILL OPERATE THE
 EMERGENCY POWER SYSTEM, WHICH CAN CAUSE DAMAGE TO THE

 COMPONENTS OF THE SYSTEM.
 (9)  
Slowly turn the interior handle in the open direction until the cams on the girt bar slider cranks lift up and are clear of the girt bar sliders.

 S 822-061

 (10)
 Move the girt bar sliders toward the middle of the girt bar (1).

 S 212-062

 (11)
 Look for corrosion, damage, and unwanted material on the leaf springs.

 S 712-063

 (12)
 Make sure the leaf springs apply sufficient pressure to hold the girt bar sliders.

 S 352-064

 (13)
 If the leaf springs do not hold the girt bar sliders, then do these steps:

 (a)  
Disengage the girt bar sliders from the floor fittings.

 (b)  
Lift the girt bar (1) and remove the girt bar sliders.

 (c)  
Measure the height of the leaf spring as shown (View A-A, Fig. 201).

 (d)  
If the height of the leaf spring is not correct, then carefully bend the leaf spring up to get the correct dimension.

 (e)  
Install the girt bar sliders on the girt bar (1).

 (f)  
Engage the girt bar sliders in the floor fittings.

 (g)  
Make sure the girt bar (1) has equal clearances between the ends of the girt bar (1) and the stop tabs on the floor fittings.

 S 822-065
 (14)
 Move the girt bar sliders back into the floor fittings.

 S 862-066

 (15)
 Turn the interior handle back to the latched position.

 S 212-067

 (16)
 Make sure the cams of the girt bar mechanism go into the slots on the girt bar sliders.

 (17)
 Move the mode selector lever to the DETACH position.

 S 862-068
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 25-66-10
 ALL  ú ú 01 Page 211 ú Sep 20/94
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A

757
MAINTENANCE MANUAL

 S 092-071
 (18)
 Remove the safety pin from the inflation cylinder regulator.

 S 432-074

 (19)
 Put the safety pin into the stowage pouch on the escape slide (2).

 S 412-000

 (20)
 Install the cover for the escape slide (2) (Ref 25-66-01).

 S 092-080

 (21)
 Remove the safety pins from the emergency power reservoir.

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：757 AMM 飛機維護手冊 EQUIPMENT/FURNISHINGS 2(89)