1. SLIDE OR SLIDE-RAFT PACK
B 
1. SLIDE OR 
SLIDE-RAFT 
PACK  LOWER SHELF  HARNESS LATCH 
RELEASE STRAP 
A  GUIDE RING 
LATCH CHAIN 
GIRT 

LOWER RELEASE STRAP SHELF GIRT
HARNESS LATCH
B A
3. GIRT BAR 3. GIRT BAR
NO. 1, 2, OR 4 PASSENGER DOOR
(COVER NOT SHOWN) INBD A-A
LATCH ASSEMBLY
SEE B
HARNESS LATCH
LATCH CHAIN 3
LATCH CHAIN 1
2
RELEASE RELEASE
STRAP/LATCH RELEASE STRAP/LATCH
CHAIN FASTENER STRAP CHAIN FASTENER GIRT RELEASE STRAP GUIDE RING RELEASE STRAP
SEE A
B-B
1
DOORS 1L, 1R, 2L, AND 2R
2
DOORS 4L AND 4R
3
LENGTH MUST BE 4 CHAIN LINKS
Release Strap Figure 403 (Sheet 1)
A15357
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 25-66-01
 ALL  ú ú 05 Page 406 ú May 28/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A

757
MAINTENANCE MANUAL

RELEASE STRAP GIRT BAR

Release Strap
Figure 403 (Sheet 2)

EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 25-66-01
 ALL  ú ú 03 Page 407 ú Mar 20/97
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A15366
A

757
MAINTENANCE MANUAL

5 LATCH  4 CLEVIS LATCH 
DIAMETER ROD 0.25 INCH (6.35 mm) 
NOTE:____  PLUS OR MINUS 5 DEGREES. MUST RELEASE AT 20 DEGREES THE LATCH ASSEMBLY  20` |5`  20` |5` 
B LATCH ASSEMBLY 

4
MAKE SURE THAT THE CLEVIS CAN ROTATE FREELY IN THE LATCH BLOCK ASSEMBLY.

5 YOU MUST USE LESS THAN TEN POUNDS OF FORCE TO RELEASE THE LATCH.
Release Strap Figure 403 (Sheet 3)
L97904
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 25-66-01
 ALL  ú ú 02 Page 408 ú May 28/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A

757 MAINTENANCE MANUAL
 E. Prepare for Removal
 S 494-001
 WARNING: MAKE SURE YOU INSTALL THE SAFETY PIN SET ON THE CORRECT
_______ EMERGENCY POWER RESERVOIR. ACCIDENTAL OPERATION OF THE EMERGENCY POWER RESERVOIR CAN CAUSE INJURY OR DAMAGE.
 (1)  Install the safety pin set on the correct emergency power reservoir.
 NOTE: The reservoirs for the No. 1 passenger doors are left of
____ the airplane center line above the ceiling between the doors. The reservoir for the right No. 1 door is left of the reservoir for the left No. 1 door. The reservoirs for the No. 2 and 4 passenger doors are above each door.
 S 864-002
 (2)  
Close and latch the door.

 S 824-003

 (3)  
Move the mode selector lever to the DETACH position.

 S 014-006

 (4)  
Remove the cover (2) as follows (Fig. 401):

 (a)  
Release the center latch to free the latch strap.

 (b)  
Pull the bottom of the cover (2) inboard to let the latch strap slide through the slots in the center latch.

 (c)  
Pull the upper latch handles to release the upper latches.

 (d)  
Pull the cover (2) inboard until the latch strap clears the center latch.

 (e)  
Remove the cover (2).

 S 494-007
 (5)  Install the safety pin into the inflation cylinder valve on the slide pack.
 NOTE: The safety pin is kept in a pouch on the slide pack.
____
 S 824-103
 (6)  If you cannot fully install the safety pin in the lock pin housing on the valve assembly, do these steps:
 (a)  Install an allen wrench in the center of the pulley housing.
 NOTE: You can use an allen wrench with a long handle for
____
 easier access.

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：757 AMM 飛機維護手冊 EQUIPMENT/FURNISHINGS 2(77)