MODULE 3 IN FULLY BRACKET
RETRACTED POSITION
FORWARD (NO. 1) CARGO DOOR
FWD FWD
FLOOR SYSTEM INBD
ASSEMBLY (REF)
LIMIT SWITCH FORWARD CARGO LOADER SENSOR RETRACT LIMIT SWITCH A
C
ROLLER GUIDE
ASSEMBLY (PART
OF MODULE 3)
NS
MICRO SWITCH
NS
ACTIVE SURFACE

NS

LIMIT
SWITCH ACTUATOR
(MAGNET)
BRACKET SIDEWALL
LINING (REF) LIMIT SWITCH ACTUATOR (MAGNET)
C
RECEPTACLE
B-B

ESCUTCHEON
(REF)  SCREW 
WASHER  0.50 |0.20 INCH 
(2 PLACES) 
FWD 
ROLLER GUIDE 
A-A  ASSEMBLY (PART  SHIM 
OF MODULE 3) 

LIMIT
BRACKET
SWITCH SENSOR INBD
C-C
Forward Cargo Loader Retract Limit Switch Installation
Figure 401

EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. AIRPLANES WITH FORWARD CARGO LOADER ú

 25-51-07
 ú ú 06 Page 402 ú Dec 20/96
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
757 MAINTENANCE MANUAL
FWD CARGO LOADER

EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. AIRPLANES WITH FORWARD CARGO LOADER ú

 25-51-07
 ú ú 08 Page 403 ú Dec 20/96
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A

757
MAINTENANCE MANUAL

FWD

INBD
TRIGGER PLATE
FORWARD CARGO LOADER EXTEND LIMIT SWITCH
INBD

Forward Cargo Loader Extend Limit Switch Installation
Figure 402 (Sheet 2)

EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. AIRPLANES WITH FORWARD CARGO LOADER ú

 25-51-07
 ú ú 09 Page 404 ú Dec 20/96
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A

757
MAINTENANCE MANUAL

 S 034-008
 (7)  
Remove the stops from the aft end of module 1.

 S 984-009

 (8)  
Move module 1 under module 2 to get access to the limit switch sensor.

 D. Procedure - Remove the Retract Limit Switch Sensor
 S 014-010
 (1)  
Remove the sidewall panel near the sensor to get access to the wire splice (Ref 25-50-02).

 S 034-011

 (2)  
Disconnect the electrical wires from the sensor.

 S 034-041
 CAUTION: MAKE SURE YOU ARE CAREFUL WHEN YOU PULL THE SENSOR FROM THE
_______ RECEPTACLE. DAMAGE TO THE ELECTRICAL WIRES CAN EASILY OCCUR.
 (3)  
Remove the screws that hold the sensor to the receptacle, and pull the sensor from the receptacle.

 S 024-013

 (4)  
Remove the sensor.

 E. Procedure - Install the Retract Limit Switch Sensor
 S 434-002
 (1)  
Connect the electrical wires to the sensor.

 S 434-003

 (2)  
Put the sensor on the receptacle and install the screws.

 (3)  
Install the sidewall panel (Ref 25-50-02).

 S 414-004
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. AIRPLANES WITH FORWARD CARGO LOADER ú

 25-51-07
 ú ú 09 Page 405 ú Dec 20/96
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A

757 MAINTENANCE MANUAL
 F. Put the Airplane Back in its Usual Condition.
 S 434-038
 (1)  
Install the stops on the aft end of module 1.

 S 434-039

 (2)  
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：757 AMM 飛機維護手冊 EQUIPMENT/FURNISHINGS 2(52)