S 434-092

 (31)
 Attach the velcro patch (located on the D-ring end of the survival kit strap) to the velcro patch (located on the door bulb seal support on the hinged side of the door) (View F, Fig. 402).

 S 434-091
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 25-66-01
 ALL  ú ú 10 Page 416 ú May 28/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A

757 MAINTENANCE MANUAL
 S 434-116
 (32) Make sure the D-ring is completely outside the cover assembly when installed.
 H. Put the Airplane Back to Its Usual Condition
 S 094-094
 WARNING: MAKE SURE YOU REMOVE THE SAFETY PIN FROM THE INFLATION
_______ CYLINDER. FAILURE TO REMOVE THE SAFETY PIN WILL PREVENT THE INFLATION OF THE SLIDE IN AN EMERGENCY.
 (1)  
Remove the safety pin from the inflation cylinder valve on the slide pack (1).

 S 094-097

 (2)
Put the safety pin into the stowage pouch on the slide pack (1).

 S 204-100

 (3)  
Do the girt bar inspection/check (AMM 25-66-10/201).

 S 414-101

 (4)  
Install the cover (2) as follows (Fig. 401):

 (a)  
Put the bottom of the cover (2) at the bottom of the slide pack (1).

 (b)  
Push the latch strap through the upper slots in the center latch until the strap protrudes outside the cover (2).

 (c)  
Move the top of the cover (2) outboard and align the upper latches.

 (d)  
Lift the upper latch handles, engage the upper latches, and release the latch handles.

 (e)  
Hold the end of the latch strap, push the cover (2) firmly against the door bulb seals, pull on the latch strap, and push in the center latch.

 (f)  
Push the end of the latch strap through the lower slot in the center latch.

 (5)  
Remove the safety pin from the emergency power reservoir.

 S 094-102
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 25-66-01
 ALL  ú ú 09 Page 417 ú May 28/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A

757 MAINTENANCE MANUAL
 NO. 1, 2, AND 4 PASSENGER DOOR ESCAPE SYSTEM - INSPECTION/CHECK
_______________________________________________________________
 1.  General_______
 A.  This procedure contains two tasks.
 (1)  
The first task is to examine the escape slide, the girt bar, and the girt bar indication system on the No. 1, 2, or 4 passenger door.

 (2)  
The second task is to examine the inflation cylinder pressure gage.

 B.  Task two is included in task one. Thus, if you do task one, then it is not necessary to do task two.
 TASK 25-66-01-206-001
 2.  No. 1, 2, or 4 Passenger Door Escape System Check (Fig. 601)_________________________________________________
 A.  General
 (1)  In this task an escape slide or slide-raft is referred to as an escape slide.
 B.  References
 (1)  52-11-02/401, Door Lining
LINING
GREEN PRESSURELOWER DOOR GAGELINING
NEEDLE COVER
PRESSURE GAGE SEE
A

A
No. 1, 2 and 4 Passenger Door Escape System
Figure 601

EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 25-66-01
 ALL  ú ú 01 Page 601 ú Dec 20/96
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A

757
MAINTENANCE MANUAL

 C. Access
 (1)  Location Zones
 831 No. 1 Passenger Door (Left)
 832 No. 2 Passenger Door (Left)
 836 No. 4 Passenger Door (Left)
 841 No. 1 Passenger Door (Right)
 842 No. 2 Passenger Door (Right)
　
中國航空網(wǎng) m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：757 AMM 飛機(jī)維護(hù)手冊(cè) EQUIPMENT/FURNISHINGS 2(81)