78-31-02
 ALL  ú ú N01 Page 403 ú Feb 15/99
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / PW4000 SERIES /747-400 / ENGINES/MAINTENANCE MANUAL ////////////////////////
S 024-030-N00
 (7)  Remove the latch bands from the thrust reverser.
 NOTE: The T-bolt latch handle is attached to the latch band on the
____ right side of the engine. The latch band bracket is attached to the latch band on the left side of the engine.
 TASK 78-31-02-404-010-N00
 3. Install the Latch Bands
_______________________
 A. References
 (1)  
AIPC 78-31-01, Fig. 1

 (2)  
AMM 27-62-00/201, Speedbrake Control System

 (3)  
AMM 71-11-04/201, Fan Cowl Panels

 (4)  
AMM 78-31-00/201, Thrust Reverser System

 (5)  
AMM 78-31-02/501, Thrust Reverser Latch Bands

 B.
Access

 (1)  
Location Zone 415 and 416 Engine 1 - Thrust Reverser Halves 425 and 426 Engine 2 - Thrust Reverser Halves 435 and 436 Engine 3 - Thrust Reverser Halves 445 and 446 Engine 4 - Thrust Reverser Halves

 (2)  
Access Panel
 413 and 414 Fan Cowl Panels - Engine 1
 423 and 424 Fan Cowl Panels - Engine 2
 433 and 434 Fan Cowl Panels - Engine 3
 443 and 444 Fan Cowl Panels - Engine 4

 C.
Install the Latch Bands (Fig. 401).

 S 034-011-N00
 (1)  Make sure the T-bolt latch handle that holds the latch band on the bottom of the engine is open.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 78-31-02
 ALL  ú ú N01 Page 404 ú Feb 15/99
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
S 434-031-N00
 (2)  
Put the anchor strap in the correct position in the saddle fitting
 on the top of the engine.

 S 424-032-N00

 (3)  
Attach the latch band to the anchor strap with the latch band pins
 and the washers.

 NOTE:____Install each latch band pin from the aft side. Do not put the washer below the head of the latch band pin.
 (a)  Install the cotter pins in the latch band pins.
 S 434-033-N00
 (4)  Install the retainers on the anchor strap with the bolts and the
 washers.

 (a)  Put the lockwire on the bolts.
 S 434-012-N00
 (5)  
Install the latch band retainers (22 locations) with the bolts and
 the washers.

 S 824-013-N00

 (6)  
Adjust the T-bolt latch handle (AMM 78-31-02/501).

 S 434-039-N00
 CAUTION: MAKE SURE THE T-BOLT IS CORRECTLY ENGAGED IN THE RECEIVER OF
_______
 THE VEE-GROOVE LATCH BAND BEFORE YOU CLOSE THE T-BOLT LATCH
 HANDLE. FAILURE TO OBEY THIS INSTRUCTION CAN CAUSE DAMAGE TO
 THE T-BOLT OR THE RECEIVER ON THE VEE-GROOVE LATCH BAND.

 (7)  
Close the T-bolt latch handle on the bottom of the engine to lock
 the latch band.

 D.
Put the Airplane Back to Its Usual Condition.

 (1)  
Close the fan cowl panels (AMM 71-11-04/201).

 S 444-035-N00

 (2)  
Do the activation procedure for the thrust reversers
 (AMM 78-31-00/201).

 S 444-036-N00

 (3)  
Do the activation procedure for the speed brake control system
 (AMM 27-62-00/201).

 (4)  
Remove the DO-NOT-OPERATE tags from the thrust reverser levers.

 S 414-034-N00
 S 864-037-N00
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 78-31-02
 ALL  ú ú N01 Page 405 ú Feb 15/99
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
LATCH BANDS - ADJUSTMENT/TEST
_____________________________
 1.  General
_______
 A.  This procedure has a check of the force you must use to close the T-bolt latch handle.
 B.  You can find the T-bolt latch handle on the lower bifurcation of the thrust reverser.
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 EXHAUST 1(91)