NOTE: It is easier to install the aft hinge nut with the thrust
____ reverser open. Install and tighten the aft hinge nut from behind the thrust reverser, through the clearance between the strut and reverser upper bifurcation.
 (a)  Tighten the nut (9).
 S 824-031-N00
 (12) Make sure the vee-flange of the thrust reverser aligns with the vee-groove on the engine fan case.
 (a)  If it is necessary, move the thrust reverser half on the hinge bolts.
 S 414-032-N00
 WARNING: OBEY THE INSTRUCTIONS IN THE PROCEDURE TO CLOSE THE THRUST
_______ REVERSERS. IF YOU DO NOT OBEY THE INSTRUCTIONS, INJURIES TO PERSONS AND DAMAGE TO EQUIPMENT CAN OCCUR.
 CAUTION: MAKE SURE THE VEE-FLANGE GOES INTO AND FULLY ENGAGES THE ENGINE
_______ VEE-GROOVE WHEN YOU CLOSE THE THRUST REVERSER. DAMAGE TO THE THRUST REVERSER CAN OCCUR IF THE VEE-FLANGES DO NOT ALIGN.
 (13) Close the thrust reverser half with the sling assembly (AMM 78-31-00/201).
 NOTE: Do not latch the thrust reverser halves.
____
 S 094-033-N00
 (14) Remove the thread protectors from the center and forward hinge bolts.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 78-31-01
 ALL  ú ú N01 Page 414 ú Feb 15/98
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
S 434-034-N00
 (15) Install the washers (8) and nuts (9) on the center and forward hinge bolts.
 NOTE: You can get easier access to the forward and center hinge
____
 bolts and nuts with the thrust reverser closed.

 (a) Tighten the nuts (9).
 S 014-075-N00 WARNING: OBEY THE INSTRUCTION IN THE PROCEDURE TO OPEN THE THRUST
_______ REVERSERS. IF YOU DO NOT OBEY THE INSTRUCTIONS, INJURIES TO PERSONS AND DAMAGE TO EQUIPMENT CAN OCCUR.
 (16) Open the thrust reverser to the 45 degree position with the sling assembly (AMM 78-31-00/201).
 NOTE: Do not release the hoist tension.
____
 S 494-036-N00 WARNING: MAKE SURE THE THRUST REVERSER IS CORRECTLY HELD BY THE
_______ HOLD-OPEN RODS AND SLING HOIST. IF THE THRUST REVERSER IS NOT CORRECTLY ATTACHED, THE THRUST REVERSER CAN SUDDENLY CLOSE AND CAUSE INJURY TO PERSONS.
 (17)
 Engage the hold-open rod to the 45 degree position.

 (a) Make sure the hold-open rod is extended and locked.
 S 434-037-N00

 (18)
 Install the rod end of the opening hydraulic actuator on the attach point at the thrust reverser upper bifurcation (AMM 78-31-06/401).

 NOTE: Make sure the rod end of the opening actuator is fully
____
 extended (AMM 78-31-06/401).

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 78-31-01
 ALL  ú ú N01 Page 415 ú Oct 10/95
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / PW4000 SERIES /747-400 / ENGINES/MAINTENANCE MANUAL ////////////////////////
S 874-083-N00
 (19) Operate the opening system for the thrust reverser to bleed the air which is caught in the opening system with the steps that follow:
 (a)  
Connect the flex hose of the opening system which is installed on the thrust reverser to the strut installed union.

 (b)  
Loosen the flex hose on the fitting of the opening actuator.

 (c)  
Operate the hand pump until the engine oil leakage starts from the loose flex hose fitting.

 (d)  
Tighten the flex hose on the fitting for the opening actuator to 30-40 pound-inches.

 WARNING: OBEY THE INSTRUTCTIONS IN THE PROCEDURE TO OPEN AND CLOSE
_______ THRUST REVERSERS. IF YOU DO NOT OBEY THE INSTRUCTIONS, INJURIES TO PERSONS AND DAMAGE TO EQUIPMENT CAN OCCUR.
 (e)  
Do the steps to remove the air from the opening system (AMM 78-31-06/401).

 (f)  
Open the thrust reverser (AMM 78-31-00/201).

 (g)  
Make sure the hold-open rod is fully extended and locked.

 (h)  
Examine the opening actuator and flex hoses for leakage.

 S 434-038-N00
 (20) Connect the systems that follow between the strut and thrust reverser.
 (a)  
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 EXHAUST 1(72)