(b)
P180, DC Power Distribution Panel
1) 180J26, FLT RCDR DC
S 024-003
(2) Remove the DFDAC YMXA18 from the MAWEA card file M7952 (AMM 31-51-02/401).
TASK 31-31-06-404-013
3. Digital Flight Data Acquisition Card Installation (Fig. 401)_________________________________________________
A. References
(1)
AMM 24-22-00/201, Manual Control
(2)
AIPC 31-31-03
(3)
SSM 31-31-01
(4)
WDM 31-31-11, WDM 31-31-12
B. Access
(1) Location Zone 116 Area between Nose Gear Wheel Well and Fuselage, RH 221/222 Control Cabin
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
31-31-06
ALL ú ú 01 Page 401 ú Jun 18/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
MAINTENANCE MANUAL
SEE A
DIGITAL FLIGHT DATA ACQUISITION CARD (DFDAC)
SEE B
MAWEA CARD FILE A
CARD REMOVAL TAB
RED LED
YELLOW LED
HANDLE
MONITOR
JACKS
Digital Flight Data Acquisition Card Installation
Figure 401
HOLD-DOWN SCREW
DFDAC B
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
31-31-06
ALL ú ú 01 Page 402 ú Oct 10/88
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
C. Procedure
S 864-005
(1) Open these circuit breakers and attach DO-NOT-CLOSE tags:
(a)
P7, Overhead Circuit Breaker Panel
1) 7A01, MAWEA PWR A
2) 7B01, MAWEA PWR B
(b)
P180, DC Power Distribution Panel
1) 180J26, FLT RCDR DC
S 424-006
(2)
Install the DFDAC YMXA18 into the MAWEA card file M7952 (AMM 31-51-02/401).
S 864-007
(3)
Remove the DO-NOT-CLOSE tags and close these circuit breakers:
(a)
P7, Overhead Circuit Breaker Panel
1) 7A01, MAWEA PWR A
2) 7B01, MAWEA PWR B
(b)
P180, DC Power Distribution Panel
1) 180J26, FLT RCDR DC
S 864-009
(4)
Supply electrical power (AMM 24-22-00/201).
S 744-010
(5)
Make sure the red and yellow LEDs on the DFDAC come on for approximately 20 seconds.
(6)
Remove electrical power (AMM 24-22-00/201).
S 864-011
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
31-31-06
ALL ú ú 01 Page 403 ú Jun 18/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
UNDERWATER LOCATOR BEACON - MAINTENANCE PRACTICES
_________________________________________________
1. General_______
A. This procedure has these tasks:
(1)
A removal of the underwater locator beacon (ULB).
(2)
A replacement of the ULB Battery.
(3)
An operational test of the ULB.
(4)
An installation of the ULB.
B. The underwater locator beacon ULB is attached to the front of the flight data recorder. The flight data recorder is installed on the E8 electronic equipment rack in the aft equipment center.
TASK 31-31-09-002-001
2. Underwater Locator Beacon Removal (Fig. 201)_________________________________
A. General
(1) The ULB has a battery as the power source. The ULB has no external electrical connections.
B. Access
(1) Location Zone
273 Area Above Ceiling, Left
C. Removal Procedure 中國航空網 m.k6050.com 航空翻譯 www.aviation.cn 本文鏈接地址：747-400 AMM 飛機維護手冊 指示/記錄系統 1(59)
