75-32-02
ú ú C02 Page 505 ú Jul 12/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / /
CFM56 ENGINES
737-300/400/500/ /MAINTENANCE MANUAL ////////////////////////
S 975-017-C00
(14) Refer to the steps that follow for an example of the VBV kicker system adjustment:
(a) Initial Condition
1) After the free lever was adjusted with the notch of the kicker stop, these measurements are noted: a) With the VBV's in the closed position:
L1 = 4.02 inch (102.35 mm) b) With the VBV's at the switch point: L2 = 3.61 inch (91.75 mm) 2) Calculate the difference, DL, between L1 and L2
0.41 inch (10.6 mm) 3) Thus, the feedback rod should be adjusted: a) DL measured is more than 0.34 inch (8.65 mm) (DL
nominal) b) 0.41 inch (10.6 mm) - 0.34 inch (8.65 mm) = 0.07 inch
(1.95 mm).
c) Shorten the feedback rod - turn the clevis rod clockwise by 4 half turns 0.08 inch (2.0 mm).
(b) AFTER 0.08 INCH (2.0 MM) ADJUSTMENT
1) With the VBV's in the closed position:
L1 = 3.9 inch (100.5 mm)
2) With the VBV's at the switch point:
L2 = 3.6 inch (91.75 mm)
3) Calculate the difference, DL, between L1 and L2
DL = 0.35 inch (8.75 mm) 4) DL is in the limits, no additional adjustment is necessary.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ENGINES POST-CFMI-SB 72-580 ú
75-32-02
ú ú C01 Page 506 ú Jul 12/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / /
CFM56 ENGINES
737-300/400/500/ /MAINTENANCE MANUAL ////////////////////////
BLEED VALVE STOP MECHANISM - INSPECTION/CHECK
_____________________________________________
1. General
_______
A. The inspection of the stop mechanism is a lubrication recommendation of the uniballs.
TASK 75-32-02-606-003-C00
2. Bleed Valve Stop Mechanism Inspection
_____________________________________
A. Consumable Materials
(1) D00579 Water Repellent (CP2857)
B. References
(1)
AMM 70-10-01/201, Consumable Materials
(2)
AMM 71-11-02/201, Fan Cowl Panels
(3)
AMM 75-32-02/401, Bleed Valve Stop Mechanism
(4)
AMM 78-31-00/201, Thrust Reverser System
C. Procedure
S 016-005-C00
(1) Open the left fan cowl panel (AMM 71-11-02/201).
S 016-006-C00
WARNING: OBEY THE INSTRUCTIONS IN THE PROCEDURE TO OPEN THE THRUST
_______ REVERSERS. IF YOU DO NOT OBEY THE INSTRUCTIONS WHEN YOU OPEN THE THRUST REVERSERS, INJURIES TO PERSONS OR DAMAGE TO EQUIPMENT CAN OCCUR.
(2)
Open the left thrust reverser (AMM 78-31-00/201).
S 646-004-C00
(3)
Lubricate the exposed sides of the uniballs, with three to four drops of water repellant (CP2857).
(a)
Let the lubricant soak for 2-3 minutes.
(b)
Manually turn the uniballs in all directions.
NOTE: If binding or frozen slightly, use an open-end wrench on
____ the linkage to turn the rod end.
(c)
Apply three to four more drops of lubricant if it is necessary.
(d)
Move the uniballs in all directions until movement is smooth and free.
(e)
Wipe off the excess lubricant.
(f)
If the uniballs will not become free, replace the stop mechanism (AMM 75-32-02/401).
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
75-32-02
ALL ú ú C01 Page 601 ú Jul 15/97
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / /
CFM56 ENGINES
737-300/400/500/ /MAINTENANCE MANUAL ////////////////////////
S 416-007-C00
WARNING:_______ OBEY THE INSTRUCTIONS IN THE PROCEDURE TO CLOSE THE THRUST
REVERSERS. IF YOU DO NOT OBEY THE INSTRUCTIONS WHEN YOU CLOSE
THE THRUST REVERSERS, INJURIES TO PERSONS OR DAMAGE TO
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 空氣 AIR(99)
