S 863-042

 (6)
Make sure these components are in the closed position (Fig. 303):

 (a)  
Wing pressure relief valves (4 locations)

 (b)  
Landing gear doors

 S 483-043
 WARNING:_______INSTALL THE LOCKS ON ALL EXTENDED LEADING EDGE FLAPS. THIS WILL PREVENT INJURY FROM AN ACCIDENTAL OPERATION OF THE FLAPS.
 (7)  
Do this task for extended leading edge flaps: Extended Leading Edge Flaps Deactivation and Safety Locks Installation (AMM 27-81-00/201).

 S 483-044

 (8)  
Install the Cargo and Fuel Loading Support if the center of gravity will be out of limits (AMM 07-11-08/201).

 S 863-045

 (9)  
Make sure the onboard fuel load is in a valid fuel distribution configuration (equivalent to after a flight operation).

 (a) Transfer fuel if it is necessary (AMM 28-26-00/201).
 E. Pressure Refuel Operation Procedures
 S 653-047
 (1)  Do one of these pressure refuel operations:
 (a)  
Automatic Pressure Refueling (AMM 12-11-02/301)

 (b)  
Manual Pressure Refueling (AMM 12-11-03/301)

 (c)  
Center Wing Tank Refuel (AMM 12-11-05/301)

 (d)  
Alternate Refueling Procedures (AMM 12-11-06/301).

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 12-11-01
 ALL  ú ú 05A Page 315 ú Oct 18/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 TASK 12-11-01-603-068
 4.  Fuel Supply for APU Operation_____________________________
 A. General
 (1)  Do this task if the APU will supply power during the refuel operation.
 B. Reference
 (1)  AMM 49-11-00/201, Auxiliary Power Unit
 C. Access
 (1)  Location Zones
 223 Control Cabin, Left
 224 Control Cabin, Right

 D. APU Operation
 S 863-058
 (1)  
Make sure the No. 2 and 3 main tanks each contain a minimum of 2800 lbs (1300 kgs) of fuel.

 S 913-059

 (2)  
Operate the APU (AMM 49-11-00/201).

 S 863-060

 (3)  
Make sure the APU is started and running before you begin the refuel operation.

 S 863-062

 (4)  
Make sure the refuel operation is complete before you shutdown the APU.

 TASK 12-11-01-603-064
 5.  Alternate Fuel Supply for APU Operation_______________________________________
 A. General
 (1)  
Do this task to use a different (alternate) fuel tank to supply fuel to the APU.

 (2)  
AIRPLANES WITH A HYDROMECHANICAL SCAVENGE PUMP SYSTEM; If the inboard main tanks (MAIN 2 and 3) do not contain sufficient fuel, the outboard main tanks (MAIN 1 or 4) or the CWT can supply the APU with fuel.

 B. Reference
 (1)  
AMM 49-11-00/201, Auxiliary Power Unit

 (2)  
Location Zones
 225 Control Cabin, Left
 226 Control Cabin, Right

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 12-11-01
 ALL  ú ú 19A Page 316 ú Oct 18/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 C. Alternate Fuel Supply For APU Operation
 S 863-069
 (1)  
Make a decision about which fuel tank will supply the APU with fuel.

 S 863-070

 (2)
If the No. 1, 3 or 4 main tank will supply fuel, do these steps:

 (a)  
Make sure the fuel supply tank contains a minimum of 2800 lbs (1300 kgs) of fuel.

 (b)  
Open the No. 2 crossfeed valve.

 (c)  
Open the crossfeed valve for the fuel supply tank.

 (d)  
Operate a boost pump for the fuel supply tank.

 (e)  
Operate the APU (AMM 49-11-00/201).

 (f)  
Make sure the APU is started and running before you begin the refuel operation.

 (g)  
Make sure the refuel operation is complete before you shutdown the APU.
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 SERVICING 1(9)