SHOCK STRUT  SEE  A  AIR VALVE 
SEE  C  A 
SEE  B 
1600 1700 1800 1900 2000 2100 2200 2300 2400  X 

INFLATION PRESSURE (PSI)
1500
B
1400 1300 1200 1100
SERVICING
SERVICING

BAND
REFERENCE DATA

1000
900
FULLY COMPRESSED STRUT:
800 X = 8.15 INCHES

700 FULLY EXTENDED STRUT:
X = 34.65 INCHES

600
EXTENDED PRESSURE =

500
450 PSIG
400

9 1011121314151617181920212223242526272829303132333435 DIMENSION X (INCHES)
Wing Gear Shock Strut Servicing
Figure 301 (Sheet 1)

EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 12-15-03
 ALL  ú ú 01 Page 303 ú Jun 10/90
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
MAINTENANCE MANUAL

THESE POSITIONS SHOW THE MAXIMUM RANGE THE VENDOR CAN BEND THE INDICATOR NEEDLE FOR CALIBRATION AT ZERO.
Wing Gear Shock Strut Servicing Figure 301 (Sheet 2)
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 12-15-03
 ALL  ú ú 01 Page 304 ú Oct 10/95
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 S 493-026
 WARNING:_______ YOU MUST CAREFULLY DO THE STEPS IN THE TASKS BELOW TO INSTALL
 THE DOOR LOCKS ON THE LANDING GEAR DOORS.  THE DOORS CAN CLOSE
 QUICKLY IF YOU DO NOT INSTALL THE DOOR LOCKS CORRECTLY.  THIS

 CAN CAUSE INJURY TO PERSONS OR DAMAGE TO EQUIPMENT.
 (3)  
Do this task: "Installation of the Door Locks on the Wing Landing Gear" (AMM 32-00-30/201).

 S 493-027

 (4)  
Do this task: "Installation of the Door Locks on the Body Landing Gear" (AMM 32-00-30/201).

 S 683-004

 (5)  
Drain the hydraulic fluid from the shock strut or shock struts that you will service (AMM 32-11-02/301).

 NOTE: The referenced procedure refers to steps to clean and
____ install the flow fuse.
 S 613-005
 CAUTION: USE ONLY THE SPECIFIED HYDRAULIC FLUID WHICH IS SHOWN ON THE
_______ SHOCK STRUT. OTHER TYPES OF FLUID CAN CAUSE DAMAGE TO THE SHOCK STRUT SEALS.
 DO NOT GET HYDRAULIC FLUID ON THE TIRES. HYDRAULIC FLUID WILL CAUSE DAMAGE TO TIRES.
 CAUTION: IF YOU USE AN ALTERNATIVE FLUID, YOU MUST PRE-MIX THE LUBRIZOL
_______ AND FLUID BEFORE YOU FILL THE SHOCK STRUT. IF YOU ADD UNDILUTED LUBRIZOL DIRECTLY INTO THE STRUT IT CAN CLOG THE DRAIN VALVE AND REDUCE THE SERVICE LIFE OF THE SHOCK STRUT SEALS.
 (6)  Fill the shock strut with the specified hydraulic fluid:
 (a)  
Remove the pressure cap from the oil fill valve on the pressure gage (View C).

 (b)  
Attach the hydraulic fluid line to the oil fill valve.

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 12-15-03
 ALL  ú ú 05 Page 305 ú Oct 18/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
MAINTENANCE MANUAL

 (c)  Make sure that the shutoff valve on the lower outer cylinder is open (View C).
 NOTE: Use a 3/16-inch hex wrench to open the shutoff valve
____
 if it is necessary.

 (d)  
Fill the shock strut until the hydraulic fluid flows through the air valve port without air bubbles.

 (e)  
Close the oil fill valve.

 S 433-054
 (7)  
Install pressure cap on the oil fill valve.

 S 433-043

 (8)  
Connect the hose from the service manifold assembly to the air charging valve.

 S 613-008

 (9)  
Pressurize all the shock struts with nitrogen or dry air:

 NOTE: Make sure the air charging valves are open.
____
 CAUTION: PRESSURIZE THE BODY LANDING GEAR FIRST OR PRESSURIZE ALL
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 SERVICING 1(62)