D.  Consumable Materials
 (1)  D00509 Fluid - Hydraulic, Petroleum Base, MIL-H-6083
 NOTE: Unless you use only a small amount of fluid, approximately
____
 1.0 percent of the total, you must mix MIL-H-6083 in the
 correct proportion with Lubrizol 1395 before you fill the
 shock strut.
 You can intermix MIL-H-5606 and MIL-H-6083 or use it as an
 alternative for MIL-H-5606.
 Both MIL-H-6083 and MIL-H-5606 hydraulic fluids are optional.
 The hydraulic fluid BMS 3-32 is recommended for landing gear
 shock struts.

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 12-15-04
 ALL  ú ú 01 Page 301 ú Jun 18/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
 E.
F.
G.
A
747-400
MAINTENANCE MANUAL

 (2)
D00155 Lubrizol 1395 - Shock Strut Fluid Extreme Pressure Additive

 (3)
D00070 Oil - Hydraulic, Petroleum Base, MIL-H-5606

 NOTE: Unless you use only a small amount of fluid, approximately
____
 1.0 percent of the total, you must mix MIL-H-5606 in the
 correct proportion with Lubrizol 1395 before you fill the
 shock strut.
 The MIL-H-5606 is recommended fluid over the MIL-H-6083
 fluid.
 Both MIL-H-5606 and MIL-H-6083 hydraulic fluids are optional.
 The hydraulic fluid BMS 3-32 is recommended for landing gear
 shock struts.

 (4) D00467 Fluid - fully Formulated Hydraulic, BMS 3-32 (Recommended)
 Type I - Royco SSF, Shell SSF and Castrolaero 35 (These fluids
 contain the mixture of MIL-H-6083 and Lubrizol 1395)
 Type II - Royco LGF, Shell LGF and Castrolaero 40 (These fluids are the recommended fluid for servicing and contain the mixture of MIL-H-5606 and Lubrizol 1395)
References
 (1)
AMM 09-11-00/201, Towing

 (2)
AMM 32-00-30/201, Landing Gear Door Locks

 (3)
AMM 32-13-02/301, Body Gear Shock Strut

 (4)
AIPC 32-13-01 Fig. 5

 (5)
AIPC 32-13-02 Fig. 2Access

 (1)  
Location Zone 755 Body Landing Gear, LH 765 Body Landing Gear, RH

Procedure (Fig. 301)
 S 863-050
 (1) Make sure the airplane is not on jacks.
 S 493-025
 WARNING: YOU MUST CAREFULLY INSTALL THE GROUND LOCKS IN ALL LANDING
_______ GEAR. AN ACCIDENTAL RETRACTION OF THE LANDING GEAR CAN CAUSE INJURY TO PERSONS AND DAMAGE TO EQUIPMENT.
 (2) Install the ground locks in all landing gear (AMM 09-11-00/201).
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 12-15-04
 ALL  ú ú 01 Page 302 ú Jun 18/99
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
AIR VALVE (BELOW THE SURFACE)
SEE  ASHOCK STRUT
SEE  B
LOWER OUTER CYLINDER
X
FLOW FUSE (FOR EMERGENCY SHUTOFF) OUTER
SHUTOFF VALVE
2400 2300 2200 2100 2000 1900 1800 1700 1600 1500 1400 1300 1200 1100 1000
SERVICING
900

REFERENCE DATA
FULLY COMPRESSED STRUT:

800
X = 8.15 INCHES 700
FULLY EXTENDED STRUT: 600 X = 34.65 INCHES CYLINDER
A
PRESSURE GAGE
SEE C  MAXIMUM BEND POSITION
1
OIL FILL VALVE
B  (CHECK VALVE) INDICATOR
NEEDLE MAXIMUM BEND POSITION
C
1
1  THESE POSITIONS SHOW THE MAXIMUM RANGE THE VENDOR CAN BEND THE INDICATOR NEEDLE FOR CALIBRATION AT ZERO.
SERVICING
BAND

INFLATION PRESSURE (PSI)
400 500  PRESSURE AT FULL EXTENSION: 325 PSIG 
7  8  9  10 11 12  13 14 15 16  2317 18 19 20 21 22 24 25 26 27 28 29 30 31 32 33 34 DIMENSION X (INCHES) 
Body Gear Shock Strut Servicing Figure 301 

EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 12-15-04
 ALL  ú ú 01 Page 303 ú Oct 18/99
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 SERVICING 1(68)