NOTE:____You do not have to format a diskette for the other FMC. You can download data from both FMCs to the same diskette.
(14)
After you have made a copy of the data on the disk, send the disk to the vendor shown above.
E. Transfer Failure Indication
(1) If the disk that you put into the data loader contains an FMC Op
Program or database, the CDU will show ~................................................... | WARNING: DISK UNUSABLE | | OFP OR DB DISK INSERTED | 2...................................................1
(a)
Push the eject button.
(b)
Put the correct disk into the data loader using the above procedure.
(2) If the disk that you put into the data loader is not write-protected and contains data that is not an FMC Op Program or database, the CDU will show
~................................................... | WARNING: DISK UNUSABLE | | DISK CONTAINS DATA | 2...................................................1
(a)
Push the eject button.
(b)
Push the LSK adjacent to PRESS HERE TO RETRY>.
(3) If the disk that you put into the data loader is not write-protected
and is not formatted by the FMCPREP software, the CDU will show ~................................................... | WARNING: DISK UNUSABLE | | FORMAT DISK USING THE | | FMCPREP PC UTILITY | 2...................................................1
(a)
Push the eject button.
(b)
Push the LSK adjacent to PRESS HERE TO RETRY>.
(4) If the transfer was unsuccessful for any other reason, the CDU will
show ~................................................... | DEVICE NOT PRESENT | | DISK WAS REMOVED OR | | INTERFACE HAS FAILED | 2...................................................1
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. AIRPLANES WITH EFIS ú
34-62-01
ú ú 02 Page 104 ú Mar 12/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
FLIGHT MANAGEMENT COMPUTER SYSTEM - MAINTENANCE PRACTICES
_________________________________________________________
1. General
_______
ú A. This procedure contains these tasks:
ú (1) Installation of the FMC software with a data loader.
ú (2) Crossload of the FMC software.
ú (3) Configuration check of the FMC software.
ú (4) Installation of the FMC performance factors.
ú B. To read about software installation times and data loaders, do this task:
ú On-airplane Software Installation (AMM 20-15-11/201).
ú C. The airplane must be on the ground before you can do these tasks.
ú D. You use a Portable Data Base Loader (PDL) to install the software.
ú E. The procedure to download FMC BITE data is in the Flight Management
ú Computer System - Troubleshooting (AMM 34-62-01/101). See FMC Diagnostic
ú Data Transfer.
ú F. The FMC must contain these pieces of loadable software:
ú (1) Operational program (OPS)
ú (2) Navigational database (NDB)
ú G. The FMC can contain these pieces of loadable software:
ú (1) Software options database (OPC)
ú (2) Performance defaults database
ú (3) QRH takeoff speeds database
ú (4) ACARS datalink configuration database (Datalink)
ú (5) Flight plan database
ú H. If you install a new operational program, the databases are deleted. You
ú must install the databases again after the OPS program is installed.
ú I. AIRPLANES WITH FMC P/N 10-62225-004;
ú The operational software (OPS) U10.3 and before should not be loaded into
ú this FMC.
ú J. The operational program (OPS) does the functions related to the
ú operationand control of the FMC and its interfaces with other systems.
ú The OPS is loadable only on FMC P/Ns 10-62225-XXX for software updates
ú U7, 8, 10 and subsequent.
ú K. The navigation data base (NDB) contains all the necessary information to
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 導航 NAVIGATION 5(90)
