EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
34-12-31
ALL ú ú 04 Page 504 ú Jul 12/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
TOTAL AIR TEMPERATURE PROBE - CLEANING/PAINTING
_______________________________________________
1. General_______
A. This subject has one task. The task is to clean the material collected in the total air temperature (TAT) probe. The first procedure in this task is to clean the TAT probe while the probe is installed on the airplane. The second procedure is to clean the TAT probe when the probe is off the airplane.
TASK 34-12-31-107-011
2. Total Air Temperature (TAT) Probe Cleaning__________________________________________
A. Equipment and Materials
(1)
Compressed air source
(2)
Syringe and water or dry cleaning solvent
B. References
(1)
AMM 34-12-31/401, Total Air Temperature Probe
(2)
AMM 34-12-31/501, Total Air Temperature Probe
C. Access
(1) Location Zones
101/102 Flight Compartment
202 Lower Nose Compartment
D. TAT Probe Cleaning (While on Airplane)
S 867-012
WARNING:_______MAKE SURE THE PROBE HEAT IS NOT ON. THIS CAN CAUSE INJURY TO PERSONS.
(1) Open this circuit breaker and attach a DO-NOT-CLOSE tag:
(a) P18 Load Control Center
1) C5, TEMP PROBE
S 167-014
CAUTION:_______REMOVE THE MATERIAL FROM THE AIR INLET CAREFULLY. YOU CAN CAUSE DAMAGE TO THE SENSING ELEMENT DURING THE CLEANING PROCEDURE.
(2)
Blow compressed air into the air exit hole.
(3)
Flush the air inlet with water.
S 867-004
(4)
Remove the DO-NOT-CLOSE tag and close this circuit breaker:
S 177-015
(a) P18 Load Control Center
1) C5, TEMP PROBE
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
34-12-31
ALL ú ú 01 Page 701 ú Jul 12/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
E. TAT Probe Cleaning (While off Airplane) S 027-016
(1) Remove the TAT probe (AMM 34-12-31/401).
S 177-017 CAUTION: DO NOT USE FLUIDS THAT CONTAIN SODIUM CHLORIDE OR SULFUR
_______ COMPOUNDS TO CLEAN THE PROBE. SODIUM CHLORIDE AND SULFUR CAN CAUSE PREMATURE FAILURE OF THE PROBE.
(2)
Soak the air inlet and strut of the TAT probe with water.
S 177-018
(3)
Move the TAT probe back and forth in the water.
(a) Make sure the air inlet and strut of the TAT probe are clean. S 167-019
(4)
Blow compressed air into the air inlet.
S 727-020
(5)
Do a test of the TAT probe (AMM 34-12-31/501).
S 427-021
(6)
Install the TAT probe (AMM 34-12-31/401).
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
34-12-31
ALL ú ú 01 Page 702 ú Jul 15/93
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
1.
2.
3.
4.
A
737-300/400/500MAINTENANCE MANUAL
MACH AIRSPEED WARNING SYSTEM - DESCRIPTION AND OPERATION
________________________________________________________
General (Fig. 1)
_______
A. The mach airspeed warning system provides an aural warning to alert the flight crew when the airplane exceeds mach airspeed limits. Two mach airspeed warning systems, No. 1 and No. 2 are installed on the airplane. Each system consists of a mach/airspeed indicator installed on each pilot's instrument panel, an aural warning clacker located in the aural warning unit module, and a warning test switch installed on the aft overhead panel P5.
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 導航 NAVIGATION 1(98)
