曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

 TASK 34-12-01-715-001
 2.  Air Data System - Operational Test__________________________________
 A.  General
 (1)  The ADS operational test is a BIT (built-in-test) test. The test operates from the controls on the front panel of the ADC. During the test, stable outputs are sent to the air data instruments and are monitored. The test makes sure of the conditions that follow:
 (a)  
The ADC electronics operate correctly.

 (b)  
The interface and warning system between the computer and instruments operate correctly.

 (c)  
The instruments operate when signals are sent to them.

 B.  References
 (1)  
AMM 24-22-00/201, Electrical Power - Control

 (2)  
AMM 34-22-00/501, Electronic Flight Instrument System

 (3)  
AMM 34-28-01/501, Inertial Reference System

 C.  Access
 (1)  Location Zones
 211/212 Flight Compartment

 D.  Prepare for the Operational Test
 S 865-002
 (1)  
Supply electrical power (AMM 24-22-00/201).

 S 865-003

 (2)  
Close the ADS circuit breakers on the load control panels, P6 and P18.

 S 865-004

 (3)  
Make sure the inertial reference systems are on and operate correctly (AMM 34-28-01/501).

 S 865-005

 (4)  
Make sure the electronic flight instrument systems are on and operate correctly (AMM 34-22-00/501).

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. AIRPLANES WITH EFIS ú

 34-12-01
 ú ú 02 Page 501 ú Nov 12/99

BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 S 865-007
 (5) Close the TAT IND circuit breaker on the load control panel, P18.
 NOTE:____All the flags go out of view when you apply power. When the mach OFF flag goes out of view, a black cover goes over the readout for numbers lower than 0.400.
 E. Air Data System Test - Operational Test
 S 865-095
 (1)  
Open the NO. 1 AIR DATA COMPUTER-1 circuit breakers on the P18 panel.

 S 865-008

 (2)  
Make sure the warning flags on these captain's instruments come into view in less than the time shown.

 (a)  
Altimeter -5 seconds

 (b)  
VSI indicator - 15 seconds

 (c)  
Mach/Airspeed Indicator - 10 seconds
 1) Mach
 2) Airspeed
 3) Vmo

 

 

 S 865-011
 (3)  
AIRPLANES WITHOUT EIS; Make sure the TAT/SAT/TAS indicator goes out of view in less then 5 seconds.

 S 865-012

 (4)  
AIRPLANES WITH EIS; Make sure the TAT indication on the EIS secondary display goes out of view.

 (5)  
Close the NO. 1 AIR DATA circuit breakers.

 S 865-013
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. AIRPLANES WITH EFIS ú

 34-12-01

 ú ú 06 Page 502 ú Jul 15/98
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL
 S 755-045
 (6)  
Make sure all the warning flags go out of view.

 S 865-014

 (7)  
Open the NO. 2 AIR DATA COMPUTER-2 circuit breakers on the P6 panel.

 S 865-015

 (8)  
Make sure the warning flags on these F/O's instruments come into view in less then the time shown.

 (a)  Altimeter  - 5 seconds
 (b)  VSI indicator  - 15 seconds
 (c)  Mach/Airspeed Indicator - 10 seconds
 1)  Mach
 2)  Airspeed
 3)  Vmo

 S 865-016
 (9)  
Close the NO. 2 AIR DATA circuit breakers.

 S 865-017

 (10)
 Make sure all the warning flags go out of view.

 S 865-019

 (11)
 AIRPLANES WITHOUT EIS; Set the LIGHTS switch on the pilot's center instruments panel, P2, to the TEST position.

 (a)  Make sure all parts of the TAT/SAT/TAS indicator flash.
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 導航 NAVIGATION 1(82)