28-10-00
 ALL  ú ú 02 Page 237 ú Jul 15/97
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 S 492-380
 (9)  
Put the air duct for the heater/air blower in the fuel tank through the tank access opening.

 S 492-381

 (10)
 Bond the air duct to the airplane structure.

 S 942-382

 (11)
 Continue to have a good flow of air through the fuel tank with the air mover until you prepare to the close the fuel tank.

 (a)  Read the combustible gas indicator values every half hour or less.
 S 942-383
 (12)
 If fuel vapors get into the fuel tank that was in a fire-safe condition, get all persons out of the fuel tank until you make sure the air in the fuel tank is in a fire-safe condition again.

 S 942-384

 (13)
 Go into the fuel tank per the "Fuel Tank Entry" procedure to do maintenance.

 I.  Purging of the Center Tank
 S 012-483
 (1)
Remove the access panel for the center tank (AMM 28-11-31/401).

 S 492-484

 (2)  
VENTURI TYPE VENTILATION EQUIPMENT; Install the purge door assembly for the center tank on the access panel opening (Fig. 206).

 WARNING: PUT THE AIR MOVER IN A POSITION WHERE THE AIR CAN MOVE
_______ FREELY. IF THE EXHAUST AIR BLOWS IMMEDIATELY ON AN OBJECT, THERE IS STATIC ELECTRICITY. THIS CAN CAUSE AN EXPLOSION OR A FIRE.
 (a)  
Install the air mover on the outer side of the access door. 1) Make sure the air mover is a maximum distance from the airplane (to the limit of the hose length). 2) Put the mover on a stand with the exhaust horn pointed up.

 a)  Electrically ground the air mover to the same ground that you used for the airplane.

 (b)  
Put the exhaust air hose through the opening in the purge door the maximum possible distance into the fuel tank.

 NOTE: The access hole in the purge door must be
____ sufficiently large to hold the air hose without blockage of the flow of air from the outer side of the panel.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 28-10-00
 ALL  ú ú 02 Page 238 ú Jul 15/97
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL
 (c) (d)  Start the air compressor to supply air to the air mover to give a good flow of air to the tank.After the air supply has operated for approximately 30 minutes, put the sampling line of the combustible gas indicator (Fig. 205) as far into the fuel tank as possible.
 NOTE:____ It is recommended that you take the combustible gas indicator value regardless of the type of fuel that was contained in the fuel tank. If the fuel tank had
 contained kerosene only, then the combustible gas indicator should show zero. This shows that the tank
 atmosphere is in fire-safe and health-safe condition.
 (e) (f)  Wait one minute for each foot (300 mm) of sampling line before you take a reading.Use the table below to convert the values on the combustible gas indicator to the actual levels.
 NOTE:____ If you use a combustible gas indicator that is not listed below, follow the manufacturer's instructions to get the actual values.

 ~................................................................. | COMBUSTIBLE GAS | FOR PPM MULTIPLY | FOR LEL, MULTIPLY | | INDICATOR | VALUE BY: | VALUE BY: | ................................................................... |GASTECH 1314 | 2 | 3 | ................................................................... |GASTECH 1314SMPN | 2 | 3 | ................................................................... |GASTECH GT SERIES | 2 | 3 | 2.....................….....................….....................1
 (g)  
When the combustible gas indicator shows a concentration of 10% or less of the lower explosive limit (LEL), do these steps: 1) Remove the air hose and the purge door. 2) Install a rubber cover to give protection to the access
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 燃油 FUEL 1(31)