(c)  
Push the LSK adjacent to MAINT>.

 (d)  
Push the LSK adjacent to <DFCS.

 (e)  
Push the LSK adjacent to <LRU INTERFACE.

 (f)  
Push the LSK adjacent to <CHANNEL A AND B.

 (g)  
Push the LSK adjacent to <MCP.

 (h)  
Do the preparation steps as shown on the CDU display.

 (i)  
Push the LSK adjacent to <CONTINUE.

 (j)  
Make sure that the test is completed with no failure.

 NOTE: If a failure occurs, the test will stop and the TEST
____ FAILED indication will show on the CDU display.
 (k)  If a failure occurs, do these steps:
 1)  From the CDU display, make a note of the channel and the LRU that caused the failure.
 NOTE: Before you replace a defective component, do the
____ BITE on the system (if it is applicable) and on the FMS interface subsystems with the defective component.
 2) Push the LSK adjacent RERUN> to do the test again. 3) Make sure that the CDU display shows TEST PASSED.
 (l)  Push the LSK adjacent to <INDEX.
 S 745-013
 (3)  
Do the Current Status Quick Test (Group 10) and Altitude Alert Test (Group 15) in this task: "Operational Test - Digital Flight Control System" (Ref 22-11-01/501 or 22-11-00/501).

 (4)  
Push INIT REF key on the CDU keyboard to get out of the BITE.

 (5)  
Remove electrical power if it is not necessary (Ref 24-22-00/201).

 S 745-014
 S 865-006
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 22-11-34
 ALL  ú ú 02 Page 502 ú Mar 15/97
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 DFCS ANNUNCIATOR - REMOVAL/INSTALLATION
_______________________________________
 1.  General_______
 A.  This procedure contains two tasks. The first task is the removal of the DFCS Flight Mode Annunciator (FMA). The second task is the installation of the FMA.
 B.  You can find the DFCS Flight Mode Annunciator (FMA) on the P1 and P3 panels. The mounting screws on the front and bottom attach the FMA to the shelf. At the rear of the FMA, there are two electrical receptacles which connect to the airplane wiring connectors.
 TASK 22-11-35-004-007
 2.  DFCS Flight Mode Annunciator Removal____________________________________
 A.  Access
 (1)  Location Zones
 101 Control Cabin, Left
 102 Control Cabin, Right

 B.  DFCS Flight Mode Annunciator Removal
 S 864-005
 (1) Open these circuit breakers and attach DO-NOT-CLOSE tags:
 (a)  
P6 Circuit Breaker Panel
 1) AFCS B MACH TRIM AC
 2) AFCS B MACH TRIM DC
 3) AFDS MCP CRS-2
 4) AFCS B SNSR EXC AC
 5) AFCS B FCC DC
 6) AFCS B ENGAGE INTLK
 7) AFCS B WARN LIGHT BAT

 (b)  
P18 Circuit Breaker Panel 1) AUTOTHROTTLE AC 2) AUTOTHROTTLE DC 3) AFDS MCP DC 4) Airplanes with mechanical aileron force limiter:

 AFCS AIL FORCE LIM
 5) AFCS A SNSR EXC AC
 6) AFCS FCC DC
 7) AFCS A ENGAGE INTLK
 8) AFCS A WARN LIGHT BAT
 9) AFCS A MACH TRIM AC
 10) AFCS A MACH TRIM DC
 11) FMCS CDU NO. 1
 12) FMCS CDU NO. 2
 13) MODE ANN
 14) FMCS CMPTR

 S 024-006
 (2)  Remove the FMA:
 (a)  Remove the mounting screws on the front and bottom of the FMA.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. AIRPLANES WITHOUT EFIS ú

 22-11-35
 ú ú 02 Page 401 ú Jul 12/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 (b)  
Carefully pull out the FMA until you can get access to the electrical connectors at the rear.

 (c)  
Disconnect the electrical connectors.

 (d)  
Remove the FMA.

 TASK 22-11-35-404-004
 3.  DFCS Flight Mode Annunciator Installation_________________________________________
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 自動飛行 AUTOFLIGHT 2(43)