- FAC 22-69-00
- SEC 27 92 00
(4) If only one of the avionic units report a fault, do the fault isolation procedure that is applicable to the LRU that reported the fault.
4. Fault Isolation
_______________
A. There is no further action required for this fault symptom.
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞27-81-00∞∞∞∞∞∞∞∞∞∞Page 266
May 01/05R CES
Slats - Flag Indication Not Correct
1. Possible Causes_______________
- IPPU-SLAT (4CN)
2. Job Set-up Information______________________ Not Applicable
3. Fault Confirmation__________________
A. Procedure
(1) Examine the post flight report for a CFDS fault message with the FIN 4CN A or 4CN B shown.
4. Fault Isolation_______________
A. Procedure
(1) If the FIN 4CN A or 4CN B is shown:
(a) This is an IPPU-SLAT (4CN) fault.
(b) For the trouble-shooting procedure (Ref. 27 CFDS).
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞27-81-00∞∞∞∞∞∞∞∞∞∞Page 267
May 01/05R
CES Slats - Flap Menu Shows When Slat Menu is Selected on the CFDIU
1. Possible Causes
_______________
- SFCC-1 (21CV)
- SFCC-2 (22CV)
- RELAY-A/C ON GND (94CV)
- RELAY-A/C ON GND (96CV)
- PROX SNSR R L/G EXT 20GA
- PROX SNSR L L/G EXT 21GA
- PROX SNSR R L/G EXT 22GA
- PROX SNSR L L/G EXT 23GA
- aircraft wiring
2. Job Set-up Information
______________________
A. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION
-------------------------------------------------------------------------------
AMM 27-51-34-000-001 Removal of the SFCC (21CV,22CV)
AMM 27-51-34-400-001 Installation of the SFCC (21CV,22CV)
AMM 27-81-00-740-002 Bite Test of the Slat and Flap Control Computers
(Slat System)
ASM 27-81/02
ASM 27-81/03
3. Fault Confirmation
__________________
A. Test
(1) Do a BITE test of the applicable SFCC (Ref. AMM TASK 27-81-00-740-002).
4. Fault Isolation
_______________
A. Procedure
(1) If the flap menu comes into view when the slat menu is selected:
(a) Swop the SFCC's and repeat the test in Para. 3.A. on SFCC-1 (21CV) and SFCC-2 (22CV).
(2) If the fault has moved to the other SFCC position, swop the SFCC's back and replace the SFCC that has the fault (Ref. AMM TASK 27-51-34-000-001) and (Ref. AMM TASK 27-51-34-400-001).
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞27-81-00∞∞∞∞∞∞∞∞∞∞Page 268
May 01/05R CES
(3) If the fault did not move to the other SFCC position, swop the SFCC's back Ref. Para. (2).
(a) Make sure that there are no landing gear system faults (Ref. ATA 32-31-00)
NOTE : Main landing gear shock absorber proximity sensor faults
____
will cause this failure.
- For SFCC1 PROX SNSR R L/G EXT 20GA and PROX SNSR L L/G EXT 21GA
- For SFCC2 PROX SNSR R L/G EXT 22GA and PROX SNSR L L/G EXT 23GA
(4) If there were any landing gear faults, do the test in Para. 3.A.
(5) If the fault continues:
(a) Swop RELAY-A/C ON GND (94CV) with RELAY-A/C ON GND (96CV)
(b) Do the test in Para. 3.A. on SFCC1 and SFCC2.
(c) If the fault moves to the other system, replace the relay in the system that now has the fault.
(d) Do the test in Para. 3.A.
(6) If the fault does not move to the other system, do a check of the aircraft wiring.
- for SFCC1 from C/B 5CV to the LGCIU1 and from the RELAY A/C ON GND 94CV to SFCC1 (Ref. ASM 27-81/02).
- for SFCC2 from C/B 7CV to the LGCIU2 and from the RELAY A/C ON GND 96CV to SFCC2 (Ref. ASM 27-81/03).
(a) Repair any defect found.
(b) Do the test in Para. 3.A.
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞27-81-00∞∞∞∞∞∞∞∞∞∞Page 269
中國航空網(wǎng) m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320 Trouble Shooting Manual 排故手冊 飛行操縱 2(79)
