Subtask 72-32-00-010-060
 B. Get Access
 (1) Open the fan cowls doors: (Ref. TASK 71-13-00-010-040)
 FOR 1000EM1
 437AL, 438AR
 FOR 1000EM2
 447AL, 448AR.

 (2) Put the access platform in position. Subtask 72-32-00-040-056

 C. Make the thrust reverser unserviceable (Ref. TASK 78-30-00-481-041). Subtask 72-32-00-010-061

 D. Open the thrust reverser doors (Ref. TASK 78-36-00-010-040):
 FOR 1000EM1
 451AL, 452AR
 FOR 1000EM2
 461AL, 462AR.

 4. Procedure
_________
 (Ref. Fig. 801/TASK 72-32-00-991-301, 802/TASK 72-32-00-991-302) Subtask 72-32-00-020-052
 A. Remove the IGV and stage 3 lever arms and bushings.
 (1) Hold the lever arm with LEVER, COUNTERTORQUE - CPRSR STATOR VANE ACTUATION ARM (856A1012G01), while you loosen the vane stem nut. Do not let the vane turn.
 F 『 EEFF : ALL E Page 80272-32-00
 E E Feb 01/98 E E ECES E F 『 E C F M E E E E 56-5B E F 『 E C F M E E E E 56-5B E

 Replacement of Lever Arm and/or Vane Bushing
 Figure 801/TASK 72-32-00-991-301
 F EEFF :  ALL  『E 72-32-00 Page 803 
E  E  Feb 01/98
 E  E
 ECES  E

 IGV and Stage 3 Lever Arm Engaged Correctly and Incorrectly
 Figure 802/TASK 72-32-00-991-302

 F 『 EEFF : ALL E Page 80472-32-00
 E E Feb 01/98 E E ECES E F 『 E C F M E E E E 56-5B E E E (2) Remove the nut and washer from the vane.

 (3) Remove the lever arm from the vane with PULLER, ARM - COMPRESSOR STATOR ACTUATION (856A1051G01).

 (4) Remove the bushing from the stator case.

 F 『 EEFF : ALL E Page 80572-32-00
 E E Feb 01/98 E E ECES E TASK 72-32-00-400-003

 F  『
 E  C F M  E
 E  E
 E  56-5B  E
 E  E

 Installation of the Inlet Guide Vane (IGV) and Stage 3 Vane Lever Arms or Bushings
 1. Reason for the Job
__________________
 Self Explanatory
 2. Job Set-up Information
______________________
 A. Fixtures, Tools, Test and Support Equipment
 -------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific warning notice No specific access platform 1 m (3 ft. 3 in.) No specific Torque Wrench : range 36.00 to 220.00 lbf.in
 (0.40 to 2.60 m.daN)
 856A1012  1 LEVER, COUNTERTORQUE - CPRSR STATOR VANE ACTUATION ARM
 B. Referenced Information
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
71-13-00-010-040 Opening of the Fan Cowl Doors 71-13-00-410-040 Closing of the Fan Cowl Doors 78-30-00-081-041 Make the Thrust Reverser Serviceable after
 Maintenance 78-30-00-481-041 Make the Thrust Reverser Unserviceable for
 Maintenance 78-36-00-010-040 Opening of the Thrust Reverser Doors 78-36-00-410-040 Closing of the Thrust Reverser Doors 72-32-00-991-301 Fig. 801 72-32-00-991-302 Fig. 802
 F 『 EEFF : ALL E Page 80672-32-00
 E E Feb 01/98 E E ECES E 3. Job Set-up

 F  『
 E  C F M  E
 E  E
 E  56-5B  E
 E  E

__________
 Subtask 72-32-00-860-052
 A. Aircraft Maintenance Configuration
 (1) On the center pedestal, on the ENG panel 115VU, make sure that a warning notice is in position to tell persons not to start the engine.

 (2) On the overhead maintenance panel 50VU, make sure that the ON legend of the ENG/FADEC GND PWR/1(2) is off. Make sure that a warning notice is in position to tell persons not to energize the FADEC 1(2).

 (3) Make sure that the access platform is in position.

 Subtask 72-32-00-010-064
 B. Get Access
 (1) Make sure that the fan cowl doors are open: (Ref. TASK 71-13-00-010-040) FOR 1000EM1 437AL, 438AR FOR 1000EM2 447AL, 448AR

 (2) Make sure that the thrust reverser doors are open: (Ref. TASK 78-36-00-010-040) FOR 1000EM1 451AL, 452AR FOR 1000EM2 461AL, 462AR

 Subtask 72-32-00-040-058
 C. Make sure that the thrust reverser is unserviceable (Ref. TASK 78-30-00-481-041).
 F 『 EEFF : ALL E Page 80772-32-00
 E E Feb 01/98 E E ECES E 4. Procedure

 F  『
 E  C F M  E
 E  E
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM ENGINE 發動機 2(34)