-------------------------------------------------------------------------------
REFERENCE DESIGNATION -------------------------------------------------------------------------------
R **ON A/C 106-149, 151-156, 159-199, 201-299, 301-399, 401-499,
Post SB Post SB 46-1009 For A/C 151-152,201-203,46-1013 For A/C 151-156,201-209,
46-21-00-991-004-B Fig. 502A
**ON A/C 151-158, 201-209,
Post SB 46-1009 For A/C 151-152,201-203,
46-21-00-991-004-A Fig. 502B
**ON A/C 151-158, 201-209,
46-21-00-991-005 Fig. 503
R **ON A/C 106-149, 151-156, 159-199, 201-299, 301-399, 401-499,
Post SB 46-1013 For A/C 151-156,201-209,
46-21-00-991-005-A Fig. 503A
R **ON A/C 106-149, 151-199, 201-299, 301-399, 401-499,
3. Job Set-up__________
Subtask 46-21-00-861-052
A. Energize the aircraft electrical circuits (Ref. TASK 24-41-00-861-002).
R 1EFF : 106-149, 151-199, 201-299, 301-399, 1 46-21-00Page 502 1401-499, 1Aug 01/05 1 1 1CES 1
Subtask 46-21-00-865-053
B. Make sure that this(these) circuit breaker(s) is(are) closed:
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------
49VU AUTO FLT/MCDU/1 49VU SDAC/1/SPLY 49VU FWS/FWC1/SPLY 49VU COM/RMP/1 121VU CFDS/CFDIU/SPLY 121VU ATSU 1 121VU ATSU 1/SWTG 121VU COM NAV/VHF/3 121VU COM NAV/RMP/3 121VU COM NAV/RMP/2 121VU AUTO FLT/MCDU/2 121VU EIS/FWC2/SPLY 11CA1 3WV 3WW 2RG1 2TW 3TX1 5TX1 2RC3 2RG3 2RG2 11CA2 2WW B01F04F01G10J18L16L15L05L03L02N20Q07
**ON A/C 151-199, 201-210,
121VU AIDS/DMU 4TV K15
R **ON A/C 106-149, 151-199, 201-299, 301-399, 401-499,
Subtask 46-21-00-860-056
C. Aircraft Maintenance Configuration
(1) Do the ADIRS start procedure (Ref. TASK 34-10-00-860-002).
(2) Do the EIS start procedure (Ref. TASK 31-60-00-860-001).
R 1EFF : 106-149, 151-199, 201-299, 301-399, 1 46-21-00Page 503 1401-499, 1Aug 01/05 1 1 1CES 1
4. Procedure
_________ **ON A/C 151-158, 201-209,
Subtask 46-21-00-710-052
A. Operational Test of the ATSU Failure Warning
-------------------------------------------------------------------------------ACTION RESULT -------------------------------------------------------------------------------
1. On the RMP 1 (2, 3):
-set the ON/OFF switch to ON
-
push the VHF3 pushbutton
switch.
-
push the transfer pushbutton switch (double arrow) located between the two windows to show the ACARS indication in the ACTIVE window.
2. On the MCDU 1 (2, 3):
-push the MCDU MENU mode key.
3.
Open the circuit breakers 3TX1 and 5TX1.
4.
Close the circuit breakers 3TX1 and 5TX1.
On the MCDU 1 (2, 3):
-
the MCDU MENU page comes into view
-
the <ATSU indication is shown.
On the upper ECAM DU:
-
the COM ACARS FAULT warning message comes into view in the bottom left section.
On the MCDU MENU page:
-
the <ATSU indication goes out of view.
On the RMP 1 (2, 3):
-dashes are shown in the ACTIVE window.
On the upper ECAM DU:
-the COM ACARS FAULT warning message goes out of view after approximately one minute.
On the RMP 1 (2, 3):
R 1EFF : 106-149, 151-199, 201-299, 301-399, 1 46-21-00Page 504 1401-499, 1Aug 01/05 1 1 1CES 1
-------------------------------------------------------------------------------
ACTION RESULT -------------------------------------------------------------------------------
-dashes go out of view in the ACTIVE window
-
the ACARS indication comes into view in the ACTIVE window.
On the MCDU MENU page:
-
the <ATSU prompt comes into view after approximately one minute.
NOTE : The ATSU controls the VHF3
____ frequency at the end of the ATSU power up.
Subtask 46-21-00-710-053
B. Operational Test of the VDR3 Switching to DATA Mode with Manual Selection of a Datalink Service Provider (DSP) on the MCDU
-------------------------------------------------------------------------------ACTION RESULT -------------------------------------------------------------------------------
1. On the MCDU 1 (2, 3):
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM 信息系統 INFORMATION SYSTEMS(44)
