AC EXTERNAL POWER CONTROL (GPCU OR GAPCU) - MAINTENANCE PRACTICES
_________________________________________________________________
 TASK 24-41-00-861-002
 Energize the Aircraft Electrical Circuits from the External Power
 WARNING : MAKE SURE THAT THE AIRCRAFT IS GROUNDED.
_______
 WARNING : MAKE SURE THAT ALL THE CIRCUITS IN MAINTENANCE ARE ISOLATED BEFORE
_______ YOU SUPPLY ELECTRICAL POWER TO THE AIRCRAFT.
 CAUTION : DO NOT USE A GROUND POWER UNIT WITH A CAPACITY LESS THAN 90 KVA. IF
_______ YOU USE A LESS POWERFUL UNIT:
 -AN OVERLOAD OF THE GROUND POWER UNIT COULD OCCUR
 -IT COULD BE NECESSARY TO RESET MANY COMPUTERS ON THE AIRCRAFT.
 1. Reason for the Job
__________________
 NOTE : There are alternative methods for this procedure. This task gives one
____ of the methods. For the other methods, refer to the other tasks in this page block.
 2. Job Set-up Information
______________________
 A. Fixtures, Tools, Test and Support Equipment
 -------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
98A24403000000 1 CABLE HOLDING STRAP
 B. Referenced Information
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
12-31-31-660-001 Cold Weather Maintenance - Indicating/Recording
 systems and Navigation 12-34-24-869-002 Aircraft Grounding for the Maintenance Operations 31-60-00-860-001 EIS Start Procedure 31-60-00-860-002 EIS Stop Procedure 24-41-51-000-001 Removal of the External Power Receptacle (20XG) (for
 corrective action) 24-41-51-400-001 Installation of the External Power Receptacle (20XG) (for corrective action)
 1EFF : ALL 1 24-41-00Page 201 1 1 May 01/03R 1 1 1CES 1

 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
24-41-00-991-001  Fig. 201
 3. Job Set-up__________
 (Ref. Fig. 201/TASK 24-41-00-991-001)
 Subtask 24-41-00-860-050
 A. Aircraft Maintenance Configuration
 NOTE : In the avionics compartment, if the temperature is below -15 deg.C____ (+5.00 deg.F), do the cold-weather maintenance procedure (Ref. TASK 12-31-31-660-001).
 NOTE : When you do maintenance work on the electrical circuits, it can be____ not possible to supply electrical power to the aircraft.
 (1) The aircraft must be grounded (Ref. TASK 12-34-24-869-002).
 Subtask 24-41-00-010-050
 B. Get Access
 (1) Open the access door 121AL to get access to the external power receptacle and the panel 108VU.
 Subtask 24-41-00-480-050
 C. Install the cable holding strap
 (1) Attach the CABLE HOLDING STRAP (98A24403000000) to the feeder cable.
 (2) Connect the snap hook of the cable holding strap to the fitting on the aircraft structure.
 Subtask 24-41-00-420-050 
R  D. Connect the connector 
R R R R  WARNING : BEFORE YOU CONNECT THE GROUND POWER UNIT TO THE EXTERNAL POWER_______ RECEPTACLE OF THE AIRCRAFT, MAKE SURE THAT THE EXTERNAL ELECTRICAL POWER SUPPLY IS NOT ENERGIZED. IF IT IS ENERGIZED, DANGEROUS ARCING CAN OCCUR.

 External Power Receptacle - Location
 Figure 201/TASK 24-41-00-991-001
 1EFF :  ALL  1  24-41-00 Page 203 
1  1  Feb 01/98
 1  1
 1CES  1

 CAUTION : MAKE SURE THAT THE CABLE STRAP SUPPORTS ALL THE WEIGHT OF THE
_______ CABLE WHEN THE CONNECTOR IS CONNECTED. THIS PREVENTS DAMAGE TO THE EXTERNAL POWER RECEPTACLE.
 NOTE : Examine the external power supply-cable and the external power
____ receptacle before you do the connection. If you find corrosion or damage, or if the pins are not aligned correctly, replace the external power receptacle (Ref. TASK 24-41-51-000-001) and (Ref. TASK 24-41-51-400-001).
 (1) Connect the connector of the ground power unit to the external receptacle of the aircraft.
 4. Procedure
_________
R **ON A/C 001-049, 051-060, 101-102, 201-201,
 Subtask 24-41-00-861-051
 A. Energize the aircraft electrical circuit from the external power
 (1)
 On the ELEC panel 35VU, make sure that:

 -the GEN1, GEN2, APU GEN, BUS TIE and AC ESS FEED pushbutton switches are pushed,
 -all the other pushbutton switches are released.
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM ELECTRICAL POWER 電源2(77)