曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

edge of the PFD and expands as necessary to
display any active CAS messages (up to 14 in
a window) (Figure 16-24). If more than 14
messages appear, they can be scrolled.
NAV/COM FREQUENCIES AND
NAVIGATION DATA WINDOWS
Across the top of the PFD are avionics settings
and data indications, including VHF NAV and
COM frequencies (active and standby), and
navigation status data.
PFD CONTROLS
Each PFD is controlled by knobs and pushbutton
keys on its bezel, and/or by pilot operation
of the AFCS or MFD/FMS controller.
The following general discussion of controls
is also applicable to the other controllers.
Controls
Garmin displays (PFD and MFD) and control
panels (audio panel, AFCS controller, and
FMS controller) have various types of knobs,
buttons and switches. Refer to Figure 16-25
for PFD controls locations and Table 16-5 for
a description on those controls.
Softkeys
Along the bottom of the PFD, the bezel contains
12 “softkeys” marked with upward-pointing
triangles. These keys do not have a single,
specific, permanent function. They have different
purposes at different times, as determined
by the G1000 software.
Some (or all) softkeys have labels appearing
immediately above them on the display. The
labels change depending upon pilot settings
and/or current conditions. Navigating the
lower level menus is done through the top
level softkey menu.
When the label for a specific feature is toggled
off, the text is white on a black background.
When the label is toggled on, the text is black
on a light gray background.
When the BACK softkey is available (on the
right end of the softkeys), this key can be pressed
to escape the current menu and return to the
previous menu display. For details on the menus
for PFD softkeys. refer to Figure 16-26.
TRANSPONDER DISPLAY AND
CONTROL
The PFD depicts current transponder status in
the black XPDR box on the bottom right side
510OM-00 16-21
CITATION MUSTANG OPERATING MANUAL
4
4
2
2
5700
0
5600
5500
5300
5200
54 20
20
00
XPDR1 5537 IDNT UTC 18:07:21
IDENT TMR/REF NRST MSG
GWX FAIL - GWX IS INOPERATIVE.
CNFG MODULE - PFD1 CONFIGURATION
MODULE IS INOPERATIVE.
GMX FAIL - GMX IS INOPERATIVE.
MESSAGES
HDG NO COMP
ROL NO COMP
PIT NO COMP
ALT NO COMP
BOTH ON GPS1
BOTH ON AHRS1
BOTH ON ADC2
30.07IN
COMPARATOR
WINDOW
MESSAGES
SOFTKEY
SYSTEM
MESSAGES
WINDOW
REVERSIONARY
SENSOR
WINDOW
Figure 16-24. G1000 System Messages
13
14
15
12
8
7
6
5
4
9 10 11
1
2
3
Figure 16-25. Primary Flight Display
16-22 510OM-00
CITATION MUSTANG OPERATING MANUAL
# CONTROL DESCRIPTION
1 NAV VOL/ID Knob Controls NAV audio volume level. Press to toggle the Morse code identifier audio ON and OFF.
Volume level is shown in the NAV frequency field as a percentage.
2 NAV Frequency Transfer Key Toggles the standby and active NAV frequencies.
3 Dual NAV Knob Tunes the standby frequencies for the NAV receiver (large knob for MHz; small knob for kHz). Press to
switch the tuning box (cyan box) between NAV1 and NAV2.
4 Joystick Changes the map range when rotated. Activates the map pointer for pan when pressed.
5 BARO Knob Sets the altimeter barometric pressure. Press to enter standard pressure (29.92) or return to the
previous setting.
6 Dual COM Knob Tunes the standby frequencies for the COM transceiver (large knob for MHz; small knob for kHz).
Press to switch the tuning box (cyan box) between COM1 and COM2.
7 COM Frequency Transfer Key Toggles the standby and active COM frequencies. Press and hold this key for two seconds to tune the
emergency frequency (121.5 MHz) automatically into the active frequency field.
8 COM VOL/SQ Knob Controls COM audio volume level. Press to turn the COM automatic squelch ON and OFF. Volume
level is shown in the COM frequency field as a percentage.
9 Direct-to Key Allows the user to enter a destination waypoint and establish a direct course to the selected
destination (the destination is either specified by the identifier, chosen from the active route, or taken
from the map pointer position).
10 FPL Key Displays the active flight plan page for creating and editing the active flight plan.
11 CLR Key Erases information, cancels entries, or removes page menus.
12 Dual FMS Knob Flight management system knob. Press the FMS knob to turn the selection cursor ON and OFF.
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：CITATION MUSTANG OPERATING MANUAL 2(21)