曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

For Training Purpose Only Printed:May 2005
B757-200Aircraft Recur rent Training Manual - 28 -
(e) After the level 4 self-test starts, push the GPWS SYS TEST switch on the ground
proximity warning module for one second to go to the level 5 self-test.
(f) After the level 5 self-test starts, push the GPWS SYS TEST switch on the ground
proximity warning module for one second to go to the level 6 self-test.
NOTE: The “DISCRETE INPUT TEST, PRESS TO CANCEL” will be enunciated
approximately 60 seconds throughout this test.
(1) Air/Ground Discrete Input Test
(a) Remove the hydraulic power from the Hydraulic System A and B.
(b) Open the LANDING GEAR AIR/GND RELAY & LTS circuit breaker on panel P6-3.
(c) Make sure “NOT ON GROUND” message is enunciated.
(d) Close the LANDING GEAR AIR/GND RELAY & LTS circuit breaker on panel P6-3.
(e) Make sure “ON GROUND” message is enunciated.
(2) Landing Gear Discrete Input Test
(a) Put the landing gear handle to OFF position.
(b) Make sure “LANDING GEAR UP” message is enunciated.
(c) Engage the GND PROX GEAR INHIBIT switch on P3-7 panel.
(d) Make sure “LANDING GEAR DOWN” message is enunciated.
(e) Put the GND PROX GEAR INHIBIT switch to NORMAL position..
(f) Make sure “LANDING GEAR UP” message is enunciated.
(g) Put the landing gear handle to DN position.
(h) Make sure “LANDING GEAR DOWN” message is enunciated.
(3) Flap Discrete Input Test
(a) Supply power to hydraulic system A and B.
(b) Engage the GND PROX FLAP INHIBIT switch on P3-7 panel.
(c) Make sure “LANDING FLAPS” message is enunciated.
(d) Put the GND PROX FLAP INHIBIT switch to NORMAL position.
(e) Make sure “NOT LANDING FLAPS” message is enunciated.
(4) Glideslop Cancel Discrete Input Test
(a) Push and hold the GND PROX G/S INHB switch on the P1 or P3 panel.
(b) Make sure “GLIDESLOP CANCELED” message is enunciated.
(c) Release the PROX G/S INHB switch.
(d) Make sure “GLIDESLOP ENABLED” message is enunciated.
(5) Terrain Override Discrete Input Test
(a) Engage the TERR INHIBIT switch on P3-7 panel.
(b) Make sure “TERRAIN OFF” message is enunciated.
(c) Put the TERR INHIBIT switch on P3-7 panel to NORMAL position..
(d) Make sure “TERRAIN ON” message is enunciated.
(7) Push and release the GPWS SYS TEST switch on the ground proximity warning
module.
NOTE: This step will end the level 6 self-test.
H. Put the Airplane Back to its Usual Condition.
For Training Purpose Only Printed:May 2005
B757-200Aircraft Recur rent Training Manual - 29 -
S 865-166-002
(1) Remove electrical power if it is not necessary (AMM 24-22-00/201).
For Training Purpose Only Printed:May 2005
B757-200Aircraft Recur rent Training Manual - 30 -
EGPWC – Removal/ Installation
1. General
A. This subject has these tasks:
(1) A removal of the enhanced ground proximity warning computer (EGPWC)
(2) An installation of the EGPWC.
B. The EGPWC is on the E2 electronic equipment rack, shelf No. 4, in the Electronic
Compartment.
TASK 34-42-01-000-801
2. Ground Proximity Warning Computer Removal (Fig. 401)
A. References
(1) AMM TASK 20-10-07-000-801 p201, E/E Box Removal
B. Access
(1) Location Zones
205 Electronic Compartment
101/102 Flight Compartment
(2) Access Panel
1201 Electronics Equipment Access Door
C. Removal Procedure
SUBTASK 860-001
(1) Open these circuit breakers and attach DO-NOT-CLOSE tags:
(a) Circuit Breaker Panel, P18-1:
1) GND PROX WARN AC
2) TERRAIN DSU
SUBTASK 010-001
(2) Open the Electronic Equipment Access Door, 1201, to get access to the Electronic
Compartment
SUBTASK 020-001
CAUTION: DO NOT TOUCH THE CONNECTOR PINS OR OTHER CONDUCTORS
ON THE EGPWC . IF YOU TOUCH THESE CONDUCTORS,
ELECTROSTATIC DISCHARGE CAN CAUSE DAMAGE TO THE
EGPWC .
(3) Remove the EGPWC (AMM TASK 20-10-07-000-801 page201).
TASK 34-42-01-400-801
3. Ground Proximity Warning Computer Installation (Fig. 401)
A. References
(1) AMM 24-22-00/201 p201, Supply Electrical Power
(2) AMM 24-22-00/201 p201, Remove Electrical Power
(3) AMM 34-42-00 page CDF-201, Verify the Terrain Database Part Number
(4) AMM 34-42-00 page CDF-501, Ground Proximity Warning System - Operational Test
For Training Purpose Only Printed:May 2005
B757-200Aircraft Recur rent Training Manual - 31 -
B. Parts
AMM IPC
FIG ITEM NOMENCLATURE SUBJECT FIG ITEM
401 1 Computer 34-49-11 02 53
C. Access
(1) Location Zones
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：飛機復訓教材(23)