(d)
Rub all of the surface lightly with a moist cloth to remove the sharp particles from the surface.
(e)
Apply the Windex to the surface.
(f)
Rub the surface lightly with a clean moist cloth.
(g)
Apply the Windex one more time to the surface.
(h)
Polish the plastic with a clean cotton-flannel cloth that is moist with Windex.
J. Procedure - Clean the Carpets, Seat Upholstery and Equivalent Equipment
S 117-048
(1) To clean a small area on the surface, do the steps that follow:
NOTE:____Remove stains before too much time. It is not possible to remove some materials from the fabric if you do not remove them immediately.
(a) To remove tea, coffee, fruit juices, wines, fruit, catsup, soft and mixed drinks, chocolate, syrups, perfumes, vomit, and urine, do these steps:
CAUTION: DO NOT USE TOO MUCH HAND PRESSURE WHEN YOU RUB THE
_______ FABRIC WITH THE BONE SCRAPER. IF YOU USE TOO MUCH HAND PRESSURE, THE BONE SCRAPERS CAN CAUSE DAMAGE TO FABRICS.
1) Carefully rub the area with a bone scraper to loosen the
unwanted material from the fabric. 2) Apply mixed detergent to the area. 3) Rub the area with the bone scraper one more time. 4) Use a vacuum cleaner to remove the detergent and unwanted
materials.
NOTE: Use a soft cloth to remove the remaining moisture if
____
it is necessary.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
25-00-00
ALL ú ú 01 Page 708 ú May 20/98
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
(b)
(c)
757 MAINTENANCE MANUAL
5) If the odor continues, mix 1 teaspoon of sodium bicarbonate in 6 ounces of water. Apply the mixture on the area. Rub the area with a bone scraper. Remove the moisture with a wiper.
To remove fresh paints, greases, lipsticks, permanent inks,
oils, jet fuel, hydraulic fluid, powdered graphite, and
powdered aluminum, do these steps:
1) Remove the loose unwanted material.
2) Apply the detergent you mixed to the area and let it soak
for 30 seconds. 3) Apply more mixed detergent to the area. 4) Carefully rub the area with the blunt end of the bone
scraper to lift the unwanted material into the detergent. 5) Use a vacuum cleaner to remove the detergent and unwanted materials.
NOTE:____ Use a wiper to remove the remaining moisture if
it is necessary.
6) If the area is not fully clean, do the steps again until
the area is fully clean.
7) Use a soft fiber brush to make the fabric straight.
To remove adhesives, sealants, paints, asphalt, and gum, do these steps: 1) Use a vacuum cleaner to remove all loose unwanted material
from the fabric.
CAUTION: PUT A COVER ON THE PLASTIC AND PAINTED SURFACES
_______ ADJACENT TO THE DIRTY AREA. CHLORINATED SOLVENTS CAN CAUSE DAMAGE TO THE PLASTIC AND PAINTED SURFACES.
USE ONLY THE MINIMUM QUANTITY OF CHLORINATED SOLVENT NECESSARY TO REMOVE THE UNWANTED MATERIAL. CHLORINATED SOLVENTS CAN MOVE UNWANTED MATERIAL FROM THE DIRTY AREA AND MAKE A CLEAN AREA DIRTY.
2) Apply chlorinated solvent to the dirty area and let it soak for 30 seconds.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
25-00-00
ALL ú ú 01 Page 709 ú Jun 20/90
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
757
MAINTENANCE MANUAL
3) Carefully rub the fabric with a bone scraper to loosen the
unwanted materials.
4) Remove the unwanted material with a wiper.
5) Do the steps again until the area looks fully clean.
6) Immediately after the area looks fully clean, clean the
area one more time with detergent to remove the chlorinated solvent.
NOTE: Refer to the instructions given before for use
____
of detergents on small areas.
(d) Regular Cleaning 1) Use a vacuum cleaner to remove loose particles from the fabric.
2) Mix 2 ounces of Orvus WA paste in 1 gallon of water to make a shampoo solution.
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：757 AMM 飛機維護手冊 EQUIPMENT/FURNISHINGS 1(8)
