曝光臺 注意防騙 網(wǎng)曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費(fèi)者

14.4.7.2 The same rules apply to seemingly flat areas of snow. If you don’t have good references, avoid going there.
14.4.8 Other Traffic. Be on the look out for other traffic in the area. Other aircraft may be using your same reference point. Chances are greater of colliding with someone traveling in the same direction as you, than someone flying in the opposite direction.
14.4.9 Ceilings. Low ceilings have caught many pilots off guard. Clouds do not always form parallel to the surface, or at the same altitude. Pilots may try to compensate for this by flying with a slight bank and thus creating a descending turn.
14.4.10
Glaciers. Be conscious of your altitude when flying over glaciers. The glaciers may be rising faster than you are climbing.

15.
Operations in Ground Icing Conditions

15.1 The presence of aircraft airframe icing during takeoff, typically caused by improper or no deicing of the aircraft being accomplished prior to flight has contributed to many recent accidents in turbine aircraft. The General Aviation Joint Steering Committee (GAJSC) is the primary vehicle for government.industry cooperation, communication, and coordination on GA accident mitigation. The Turbine Aircraft Operations Subgroup (TAOS) works to mitigate accidents in turbine accident aviation. While there is sufficient information and guidance currently available regarding the effects of icing on aircraft and methods for deicing, the TAOS has developed a list of recommended actions to further assist pilots and operators in this area.
15.1.1 While the efforts of the TAOS specifically focus on turbine aircraft, it is recognized that their recommendations are applicable to and can be adapted for the pilot of a small, piston powered aircraft too.
15.2 The following recommendations are offered:
15.2.1 Ensure that your aircraft’s lift.generating surfaces are COMPLETELY free of contamination before flight through a tactile (hands on) check of the critical surfaces when feasible. Even when otherwise permitted, operators should avoid smooth or polished frost on lift.generating surfaces as an acceptable preflight condition.

Federal Aviation Administration Twentieth Edition
15.2.2 Review and refresh your cold weather standard operating procedures.
15.2.3 Review and be familiar with the Airplane Flight Manual (AFM) limitations and procedures necessary to deal with icing conditions prior to flight, as well as in flight.
15.2.4 Protect your aircraft while on the ground, if possible, from sleet and freezing rain by taking advantage of aircraft hangars.
15.2.5 Take full advantage of the opportunities available at airports for deicing. Do not refuse deicing services simply because of cost.
15.2.6 Always consider canceling or delaying a flight if weather conditions do not support a safe operation.
15.3 If you haven’t already developed a set of Standard Operating Procedures for cold weather operations, they should include:
15.3.1 Procedures based on information that is applicable to the aircraft operated, such as AFM limitations and procedures;
15.3.2 Concise and easy to understand guidance that outlines best operational practices;
15.3.3 A systematic procedure for recognizing, evaluating and addressing the associated icing risk, and offer clear guidance to mitigate this risk;
15.3.4 An aid (such as a checklist or reference cards) that is readily available during normal day.to.day aircraft operations.
15.4 There are several sources for guidance relating to airframe icing, including:
http://aircrafticing.grc.nasa.gov/index.html
http://www.ibac.org/is.bao/isbao.htm
http://www.natasafety1st.org/bus_deice.htm
15.4.1 Advisory Circular (AC) 91.74, Pilot Guide, Flight in Icing Conditions.
15.4.2 AC 135.17, Pilot Guide Small Aircraft Ground Deicing.
15.4.3 AC 135.9, FAR Part 135 Icing Limitations.
15.4.4 AC 120.60, Ground Deicing and Anti.icing Program.
15.4.5 AC 135.16, Ground Deicing and Anti.icing Training and Checking.
15.5 The FAA Approved Deicing Program Updates is published annually as a Flight Standards Information Bulletin for Air Transportation and contains detailed information on deicing and anti.icing procedures and holdover times. It may be accessed at the following web site by selecting the current year’s information bulletins:
http://www.faa.gov/library/manuals/examiners_in-spectors/8400/fsat
16. Avoid Flight in the Vicinity of Thermal Plumes (Smoke Stacks and Cooling Towers)
16.1 Flight Hazards Exist Around Thermal Plumes. Thermal plumes are defined as visible or invisible emissions from power plants, industrial production facilities, or other industrial systems that release large amounts of vertically directed unstable gases. High temperature exhaust plumes may cause significant air disturbances such as turbulence and vertical shear. Other identified potential hazards include, but are not necessarily limited to, reduced visibility, oxygen depletion, engine particulate contamination, exposure to gaseous oxides, and/or icing. Results of encountering a plume may include airframe damage, aircraft upset, and/or engine damage/failure. These hazards are most critical during low altitude flight, especially during takeoff and landing.
　
中國航空網(wǎng) m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：美國航行情報匯編 AERONAUTICAL INFORMATION PUBLICATION AIP 3(65)