S 714-027

 (15)
 Make sure the drain mast becomes hot.

 S 864-028

 (16)
 Close the fill/drain valve and service panel door (AMM 12-14-61/301).

 (17)
 Operate the lavatory washbasin faucet to fill the sink with water.

 S 864-029
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. FREIGHTERS ú

 38-31-61
 ú ú 01 Page 405 ú Oct 10/93
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 S 864-030
 (18)
 Lift the sink stopper and let the water drain from the sink.

 S 714-031

 (19)
 Make sure the water comes out of the drain mast.

 S 794-032

 (20)
 Examine the tubing connections of the drain mast for leaks.

 S 864-033

 (21)
 Remove electrical power if it is not necessary (AMM 24-22-00/201).

 S 414-034

 (22)
 If it is applicable, install the protective cover on the drain mast.

 (a)  
Put the protective cover on the drain mast.

 (b)  
Apply strips of masking tape between the drain mast and the protective cover.

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. FREIGHTERS ú

 38-31-61
 ú ú 01 Page 406 ú Oct 10/93
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 TOILET WASTE SYSTEM - DESCRIPTION AND OPERATION
_______________________________________________
 1.  General_______
 A.  This toilet waste system is the type of system that uses the toilet waste fluid that has been collected. The collected fluid, mixed with the chemical precharge, is used to clear the toilet bowl of its contents. The components that are used to receive, store, ventilate, filter, and use the collected fluid again are given below. The components or subsystems that are necessary to drain, rinse and seal the waste tank are also included.
 (1)  
The toilet tank and bowl receive and store the toilet waste. The components in the toilet tank and bowl are:

 (a)  
Toilet tank

 (b)  
Toilet bowl

 (c)  
Separator

 (d)  
The provisions to mount the components of the toilet drain, rinse, flush and ventilation systems.

 (2)  
The toilet bowl flush system moves the toilet water from the waste tank through a filter and into the toilet bowl. This clears the bowl of its contents. The components are:

 (a)  
Motor-pump-filter assembly

 (b)  
Toilet flush handle and timer

 (3)  
The toilet waste drain system moves the toilet waste from the toilet tank to the service panel during servicing. It has these components:

 (a)  
Toilet drain tube

 (b)  
Toilet tank drain valve

 (c)  
Ball valve

 (d)  
Drain valve assembly at the service panel.

 (4)  
The toilet tank rinse system transports the rinse water from the service panel to the tank to flush the tank. The rinse system is also used to put chemical precharge into the tank. The rinse system has these components:

 (a)  
Tank rinse lines

 (b)  
Spray nozzles

 (c)  
Rinse shutoff valve

 (d)  
Fluid level sensor

 (e)  
Anti-siphon valve

 (f)  
Mushroom check valve

 (5)  
The anti-siphon valve, mushroom check valve and spray nozzles are part of the motor-pump-filter assembly.

 (6)  
The toilet service panel allows ground personnel to drain, rinse (flush) and put chemical precharge into the toilet tank. The toilet service panel has these components:

 (a)  
Drain valve assembly

 (b)  
Rinse fitting and cap

 (c)  
Ball valve operating handle

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. FREIGHTERS ú
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 氣動系統 WATER/WASTE(47)