E. Install the Air Compressor
S 424-011
(1)
Put the air compressor in its installed position on the four mounts.
(2)
Install the screws and washers.
(3)
Connect the electrical connector to the air compressor.
(4)
Do this task: "Water System Pressurization" (AMM 38-15-60/201).
S 434-012
S 434-013
S 864-014
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. FREIGHTERS ú
38-15-63
ú ú 02 Page 403 ú Jun 10/94
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 747-400 MAINTENANCE MANUAL
(5) S 794-015Make sure there are no air leaks at the compressor connections.
(6) S 714-016Make sure after 5 minutes the system is fully pressurized and the compressor stops.
(7) S 414-017Do this task: "Containerized Cargo Compartment Ceiling and Sidewall Linings - Installation" to install the ceiling panels.
(8) S 864-018Remove electrical power if it is not necessary (AMM 24-22-00/201).
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. FREIGHTERS ú
38-15-63
ú ú 01 Page 404 ú Jun 10/94
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
AIR FILTER - MAINTENANCE PRACTICES
__________________________________
1. General_______
A. This procedure gives the instruction to do these tasks:
(1)
Remove the replacable element for the bleed-air line air filter.
(2)
Install the replacable element for the bleed-air line air filter.
(3)
Remove the body for the bleed-air line air filter.
(4)
Install the body for the bleed-air line air filter.
(5)
Remove (and clean) the metalic element for the air inlet filter from the air compressor with the built-in filter.
(6)
Install the metalic element for the air inlet filter from the air compressor with the built-in filter.
NOTE: If it is necessary to replace the complete filter assembly,
____ omit the steps that remove and install the element in the housing.
(7)
Remove the canister inlet air filter from the compressor with the external canister filter.
(8)
Install the canister inlet air filter on the compressor with the external canister filter.
TASK 38-15-64-002-001
2. Removal of Air Filter, Bleed-air Line, In-line Replacable Element (Fig. 201)_________________________________________________________________
A. General
(1) The bleed-air line air filter with the replacable, non-cleanable element is referred to as the filter in this task.
B. References
(1)
AMM 25-52-01/401, Containerized Cargo Compartment Ceiling and Sidewall Lining
(2)
AMM 36-00-00/201, Pneumatics
(3)
AMM 38-15-60/201, Water Tank Pressurization
C. Access
(1) Location Zone 124 Forward Cargo Container Compartment Aft Half, Right
D. Procedure
S 862-002
WARNING:_______REMOVE THE AIR PRESSURE FROM THE PNEUMATIC MANIFOLD. AIR WITH HIGH PRESSURE AND TEMPERATURE CAN CAUSE INJURY TO PERSONS.
(1) If the pneumatic manifold is pressurized, do this task: "Release the Pressure in the Pneumatic System" (AMM 36-00-00/201).
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. FREIGHTERS ú
38-15-64
ú ú 01 Page 201 ú Feb 18/02
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
MAINTENANCE MANUAL
FLOOR BEAM (REF) (STA 860)
IN-LINE AIR FILTER
SEE A WATER TANKS (REF)
FWD
AIR COMPRESSOR
CLAMP CLAMSHELL SEE B STA 850
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 氣動系統 WATER/WASTE(29)
