YESYES
15 EXAMINE THE PULLEYS IN THE
AFT LOOP.
IS A PULLEY CHAFING ON THE
PULLEY BRACKET?

MAKE SURE THAT ALL THE PULLEYS TURN FREELY. REPLACE THE PULLEYS AS NECESSARY.
Thrust Lever Binding
Figure 101 (Sheet 2)

EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 71-00-49
 ALL  ú ú C01 Page 103 ú Nov 15/92
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / /
CFM56 ENGINES
737-300/400/500/ /MAINTENANCE MANUAL ////////////////////////
PREREQUISITES: 
NONE 
____NOTE:  DECREASED MOTION OR BACKLASH IS USUAL IN THE 
SYSTEM.  DECREASED MOTION IS PERMITTED PROVIDED 
THAT THE CONDITIONS ARE AS FOLLOWS: 
.  THE THRUST LEVER ALIGNMENT IS WITHIN THE 
LIMITS 
.  THE MEC POWER LEVER TOUCHES THE FULL FORWARD 
THRUST STOP ON THE MEC BEFORE THE FORWARD 
THRUST LEVER TOUCHES THE CONTROL STAND FOR-
THRUST CONTROL  WARD STOP. 
SYSTEM HAS DECREASED  THE ENGINE GOES TO IDLE POWER WHEN THE THRUST. 
MOTION  LEVER IS MOVED TO THE IDLE POSTIION. 

Thrust Control System Has Decreased Motion
Figure 102

EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 71-00-49
 ALL  ú ú C01 Page 104 ú Nov 15/92
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / /
CFM56 ENGINES
737-300/400/500/ /MAINTENANCE MANUAL ////////////////////////
START LEVER BINDING
PREREQUISITES: NONE

YES
0A DO THE START LEVER

FRICTION TEST
(AMM 76-11-00/501).
DOES THE LEVER PASS THE TEST?

NO
YES
1 DISCONNECT THE START CONTROL PUSH-PULL CABLE FROM

THE MEC SHUTOFF LEVER.
 DOES THE START LEVER NOW MOVE FREELY?

NO
NO

2 DISCONNECT THE UPPER END OF THE PUSH-PULL CABLE FROM

THE FUEL SHUTOFF QUADRANT.
DOES THE CABLE CORE MOVEFREELY IN THE TUBE?

YES
NO

3 IN THE CONTROL STAND,

DISCONNECT THE START LEVER
LINK FROM THE START DRUM.
DOES THE START LEVER MOVEFREELY?

YES
NO

4 DECREASE THE TENSION IN THE APPLICABLE ESS( )A AND

ESS( )B CABLES.
DOES THE START DRUM IN THE CONTROL STAND TURN FREELY?

TURN FREELY. REPLACE AS NECESSARY.
Start Lever Binding Figure 103
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 71-00-49
 ALL  ú
 ú  C01  Page 105
 ú  Nov 12/01 

BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / /
CFM56 ENGINES
737-300/400/500/ /MAINTENANCE MANUAL ////////////////////////
PREREQUISITES: NONE
THRUST LEVER DOES NOT MOVE DURING AUTOTHROTTLE OPERATION

1 DO THE BITE TEST OF THE
AUTOTHROTTLE COMPUTER AND
MAKE A CHECK OF THE FLIGHT
FAULTS (AMM 22-04-00/101 OR
AMM 22-04-10/101 FOR EFIS).
DO YOU FIND THE FLIGHT FAULTS?
YES
NOTE:

NOTE:
NO
DURING AUTOTHROTTLE OPERATION, ASYMMETRIC THROTTLE SETTING COULD OCCUR IF THE THRUST REVERSER DOES NOT OPERATE CORRECTLY. THE REASONS FOR THIS COULD BE: . TOO MUCH FRICTION IN THE FORWARD THROTTLE-
CONTROL CABLE-LOOP THAT HOLDS THE TORQUE SWITCH IN THE OPEN POSITION. THIS CAUSES THE SYSTEM TO OPERATE AS IF THE AUTOTHROTTLE IS OVERRIDDEN BY THE PILOT
. A FAILED TORQUE SWITCH THAT COULD CAUSE THE SWITCH TO REMAIN IN THE OPEN POSITION. AS A RESULT THE SYSTEM WILL OPERATE AS IF THE AUTOTHROTTLE IS OVERRIDDEN BY THE PILOT
. AN AUTOTHROTTLE SERVO MOTOR THAT FAILS TO MOVE THE THROTTLE CABLE
. A FAILED AUTOTHROTTLE (A/T) COMPUTER THAT SENDS WRONG SIGNALS TO THE AUTOTHROTTLE SERVO MECHANISM.
FOR COMPUTERS WITH P/N 10-62017-25: THE MESSAGE "FWD LOOP-TORQ SW OPEN" IS GIVEN WHEN A TORQUE SWITCH IS OPEN FOR MORE THAN TEN SECONDS DURING A FLIGHT WHILE THE OTHER IS CLOSED.
　
中國航空網(wǎng) m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 動力裝置 POWER PLANT 2(34)