(b)
Make sure that the ac voltmeter shows 115 | 5 volts.

 E. Do a Test of the VSCF Operation.
 S 985-020-002
 (1)  Push and release the applicable GEN 1 or GEN 2 switch to ON.
 (a)  Make sure that the applicable GEN OFF BUS No. 1 or 2 light goes off. 1) If the GEN OFF BUS light will not go off, stop the engine
 and make sure that the power feeder cables are connected to the VSCF in the correct sequence (WDM 24-21-11 and WDM 24-21-21).
 S 865-021-002
 (2)  Put electrical loads on the ac buses.
 (a)  
Use the lights, air conditioning, fuel boost pumps, and hydraulic pumps.

 (b)  
Apply loads until the applicable generator ammeter No. 1 or 2 on the P5-4 panel shows more than 40 amperes.

 S 865-022-002
 (3)  Make sure that the power quality and the oil temperature are satisfactory.
 (a)  
Make sure that the frequency meter shows 400 | 5 Hz.

 (b)  
Make sure that the ac voltmeter shows 115 | 5 volts.

 (c)  
Push the DRIVE TEMP switch on the P5-5 panel to IN.

 (d)  
Make sure that the IN temperature indication on the applicable GEN DRIVE OIL TEMP meter on the P5-5 panel is less than 135 degrees C.

 NOTE: The usual temperature during operation of the VSCF is
____ less than the CSD. The temperature can be less than 40 degrees C.
 (e)  
Push the DRIVE TEMP switch on the P5-5 panel to RISE.

 (f)  
Make sure that the RISE temperature indication on the applicable GEN DRIVE OIL TEMP No. 1 or 2 meter on the P5-5 panel is less than 20 degrees C.

 S 865-023-002
 (4)  Remove the electrical loads that you applied before (lights, air conditioning, fuel boost pumps, and hydraulic pumps).
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù.
 VARIABLE SPEED CONSTANT FREQUENCY  ú 24-11-11
 GENERATOR/CONVERTERS  ú CONFIG 2 ú 01 Page 506 ú Nov 12/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL
 S 985-024-002
 (5)  Push and release the GRD PWR or the APU GEN No. 1 and 2 switches to ON.
 (a)  
Make sure that the applicable GEN OFF BUS No. 1 or No. 2 light comes on.

 (b)  
If the APU generator is the ground power source, make sure that the APU GEN OFF BUS light goes off.

 S 985-025-002
 (6)  
Momentarily push the applicable GEN 1 or GEN 2 switch to OFF.

 S 215-026-002

 (7)  
Look at the residual voltage.

 (a)  
Push and hold the RESID VOLTS button on the P5-13 panel.

 (b)  
Make sure that the lower scale on the ac voltmeter shows between 10 and 21 volts.

 (c)  
Release the RESID VOLTS button.

 F.
Do a Test of the Electrical Disconnect in the VSCF.

 S 985-027-002
 (1)  Operate the applicable DISCONNECT No. 1 or No. 2 switch on the P5-5 panel.
 (a)  
If the guard on the DISCONNECT switch has lockwire in it, remove the lockwire.

 (b)  
Lift the guard on the DISCONNECT switch.

 (c)  
Push and release the DISCONNECT switch.

 S 215-029-002
 (2)  
Make sure that the applicable DRIVE or LOW OIL PRESSURE No. 1 or No. 2 light comes on.

 S 215-030-002

 (3)  
Make sure that there is no residual voltage.

 (a)  
Push and hold the RESID VOLTS button.

 (b)  
Make sure that the bottom scale of the ac voltmeter shows less than 5 volts.

 (c)  
Release the RESID VOLTS button.

 (4)  
Do a shutdown of the engine (AMM 71-00-00/201).

 S 985-032-002

 (5)  
Lower the guard on the DISCONNECT switch.

 S 865-031-002
 (a)  If there was lockwire in the guard when you disconnected the VSCF, install new lockwire.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù.
 VARIABLE SPEED CONSTANT FREQUENCY  ú 24-11-11
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 電源 ELECTRICAL POWER(46)