曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

 2)  A/P Engage Switch Cruise Operation
 a)  During cruise mode of A/P operation, only one A/P is engaged at any time even if both A/P switches are selected. When the second A/P is raised, the second A/P actuator is synchronized and then energizes the detent solenoid. Disengagement of the first up channel is through the use of detent pressure switch. This assures that the second channel is fully pressurized before the first up channel is disengaged.
 3)  Dual Approach A/P Operation
 a)  When both A/Ps are engaged to CMD prior to APP OC in dual operation, the arm solenoids in both the elevator and aileron A/P actuators of the second A/P to CMD are energized. A/P actuator synchronization is continuous until APP OC plus approximately 10 seconds, when the detent solenoid of the second in command is energized.
 b)  When both A/Ps are engaged during approach and a GA is initiated, all arm and detent solenoids remain energized. If the roll A/P GA is exited, the A/P aileron detent solenoid of the second up is de-energized. When the pitch A/P GA is exited, the A/P engage switch of the second to CMD is returned to OFF.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. AIRPLANES WITHOUT EFIS ú

 22-11-00
 ú ú 13 Page 40 ú Nov 12/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 B. Engage Interlock Interface Operation (Fig. 14)
 (1)  The DFCS engage interlock information is obtained from many interfacing systems and switching signals. This schematic shows the engage interface and function of the following signals:
 (a)  
The auto speed brake module is used to sense a main wheel spin of greater than 60 knots.

 (b)  
The A/P disengage switches are in series. Pressing either switch disengages the A/P.

 (c)  
The air ground relay is used to sense the on ground condition (SQUAT). A closed switch indicates on ground.

 (d)  
The hydraulic pressure switches are used to sense when the A/P actuators are fully activated (DETENT). A closed switch indicates hydraulic pressure.

 (e)  
Two Radio ALT (LRRA) discretes are used for validity, one input is used when on dual engage and the other for single channel operation. A foreign radio altitude is transmitted to the other FCC on the X channel data bus.

 (f)  
The VHF NAV unit provides discretes for ILS DC (LOC frequency selected), VHF/LOC valid and G/S valid.

 (g)  
Transfer relays provide discretes to indicate the normal position of that system.

 (h)  
TO/GA switches are used to activate the takeoff or GA mode and provide engage interlock information.

 (i)  
The landing gear lever is used to sense gear position. A open switch indicates landing gear up.

 (j)  
The XFR control senses an AC bus XFR. The closed position indicates the normal position.

 (k)  
The aileron force limiter is monitored to assure that the limiter is in the correct position for the flap setting. Switched contacts ensure that the clutch solenoid is not energized prior to A/P engage and energized after the A/P is engaged. The AFC accessory unit provides a diode network so that if either FCC is engaged in CWS or CMD the aileron force limiter clutch is engaged.

 (l)  
The aileron force limiter sets the authority limits for the A/P. The limit is set at 17 degrees with flaps up and 25 degrees with flaps not up. Flap switch S245 controls a relay in the accessory unit which controls the ac power to a motor in the aileron force limiter. An auxiliary contact of the motor limit switch is connected in series with flap switch S290 to ensure valid authority limit.

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. AIRPLANES WITHOUT EFIS ú

 22-11-00
 ú ú 11 Page 41 ú Nov 12/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A737-300/400/500MAINTENANCE MANUAL
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù.AIRPLANES WITHOUT EFIS ú
 22-11-00
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 自動飛行 AUTOFLIGHT 1(25)