22-11-11
 ALL  ú ú 01 Page 401 ú Jul 15/91
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A

737-300/400/500MAINTENANCE MANUAL 
SEE  A  FINE ADJUSTENT NUT 

DRUM ASSEMBLY AILERON CABLE CLAMP (2 LOCATIONS) FORCE TRANSDUCER WASHER AND NUT MOUNTING BOLT  CABLE  CABLE CLAMP COARSE ADJUSTMENT (ROD END) LOCKNUTS WASHER TAB 
SEE  B 
FWD 
A 

FORCE TRANSDUCER 
AILERON DRUM ASSEMBLY 
FWD
B  AREAS FWD SHIM CLEARANCE
Figure 401 Roll Force Transducer Installation 

EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 22-11-11
 ALL  ú ú 01 Page 402 ú Jul 15/90
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL
 3) AFDS MCP DC
 4) Airplanes with mechanical aileron force limiter:

 AFDS AIL FORCE LIM 5) AUTO FLT CONT SYS A SNSR EXC AC 6) AUTO FLT CONT SYS A FCC DC 7) AUTO FLT CONT SYS A ENGAGE INTLK A 8) AUTO FLT CONT SYS A WARN LIGHT BAT
 S 864-028
 (2)  
Attach the DO-NOT-OPERATE tags to the control columns.

 S 014-004

 (3)  
Open the 1103 forward access door at the lower nose (Ref 12-31-11/201).

 S 024-005

 (4)  
Remove the force transducer:

 (a)  
Disconnect the force transducer connectors.

 (b)  
Remove the force transducer cables.

 (c)  
Wind the force transducer cables off the shaft assembly spool. Identify and write down the direction of each cable.

 (d)  
Remove the two mounting bolts, washers, and nuts that attach the force transducer to the aileron drum assembly.

 (e)  
Remove the force transducer.

 TASK 22-11-11-404-027
 3. Roll Force Transducer Installation
__________________________________
 A. References
 (1)  
12-31-11/201, Body Section 41 Access Doors and Panels

 (2)  
AMM 22-11-11/501, Roll Control Wheel Steering Force Transducer

 (3)  
24-22-00/201, Manual Control

 (4)  
29-15-00/201, Hydraulic Systems A, B and Standby

 B. Standard Tools and Equipment
 (1)  Shims (2) - 0.021 +0.003/-0.0 inch
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 22-11-11
 ALL  ú ú 01 Page 403 ú Jul 12/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 C.  Access
 (1)  
Location Zone
 202 Lower Nose Compartment

 (2)  
Access Panel.
 1103 Forward Access Door

 D.  Prepare for Installation
 S 744-032
 (1)  Find the ac null and the dc analog null of the new force transducer:
 (a)  
Connect the force transducer to the test set.

 (b)  
Measure and write down the null voltage.

 (c)  
Connect the force transducer to the system wire.

 (d)  
Close these circuit breakers:

 1)  P6 Circuit Breaker Panel a) AUTO FLT CONT SYS B MACH TRIM AC b) AUTO FLT CONT SYS B MACH TRIM DC c) AFDS MCP CRS-2 d) AUTO FLT CONT SYS B SNSR EXC AC e) AUTO FLT CONT SYS B FCC DC f) AUTO FLT CONT SYS B ENGAGE INTLK B g) AUTO FLT CONT SYS B WARN LIGHT BAT
 2)  P18 Circuit Breaker Panel a) AUTO FLT CONT SYS A MACH TRIM AC b) AUTO FLT CONT SYS A MACH TRIM DC c) AFDS MCP DC d) AIRPLANES WITH MECHANICAL AILERON FORCE LIMITER;
 AFDS AIL FORCE LIM e) AUTO FLT CONT SYS A SNSR EXC AC f) AUTO FLT CONT SYS A FCC DC g) AUTO FLT CONT SYS A ENGAGE INTLK A h) AUTO FLT CONT SYS A WARN LIGHT BAT
 (e)  Measure and write down the voltage on the FCC test connector (J7-11).
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 自動飛行 AUTOFLIGHT 1(149)