Acceptable Period 3 (For a large leakage rate)
 When the decrease in the outer-cell FQI stops.

 「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1R EFF : 001-049, 051-099, 101-149, 151-199, ∞∞28-15-00∞∞∞∞∞∞∞∞∞∞Page 253
 201-299, 401-499, Aug 01/05 CES

 4. Fault Isolation
_______________
 A. Procedure.
 (1) Troubleshooting Options.
 (a) Do the work steps (2) thru (17) in the sequence given.
 NOTE : The sequence of the steps is the height above the
____ fuel-tank (cell) floor. It starts with the lowest items, the ICTVs and goes up to the wing top skin. The last step is the Rib 15 wing interface.
 (b) Do the work steps (2) thru (17) in a sequence of your choice.

 (c) Find the FQI of the outer-cell you recorded (as the result) at Para. 3.D.(3) in the table that follows. Then do the related step given.

 Examples If the aircraft has stayed in a level attitude (since the test in Para. 3.D) the fuel (remaining) in the outer-cell can be used as an initial guide to a possible LRU failure (or leak location) as given in the examples that follow:
 - if the outer-cell fuel quantity decreases to approximately zero, possibly one or two ICTVs have failed in the open position, do step (2)

 - if the outer-cell fuel quantity decreases to approximately 71 kg (157 lb), possibly the protector-overpressure (burst disc) has operated, do step (7)

 - if the outer-cell fuel quantity decreases to approximately 134 kg (295 lb), possibly the valve-float vent has failed in the open position, do step (8).

 NOTE : The calculated (theoretical) outer-cell fuel quantities
____ given are only applicable (correct) if the surface level of the fuel in the inner-cell is lower than the bottom of Rib 15 at the end of the test.
 「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1R EFF : 001-049, 051-099, 101-149, 151-199, ∞∞28-15-00∞∞∞∞∞∞∞∞∞∞Page 254
 201-299, 401-499, Aug 01/05 CES

 OUTER-CELL FQI kg(lb) RIB-15 INSTALLATION/LRU STEP -------------------------------------------------------------------------------0 ICTVs (2) Recirculation Return Pipe (3) Spill Pipe (4) Refuel Gallery (5) CTR/Tank Vent (L/Wing Only) (6) 71 (157) Protector-Overpressure (7) 134 (295) Vent (Rib 15, STR 9 to 10) (8) 134 (295) Vent (Rib 15, STR 10 to 11) (9) Connector 4046VC1(2) (10)
 Connector 4045VC1(2) (11) Wing-Tank Vent Duct (12) between (STR13 to 14)
 Hyd Pipe 0.375 OD Blue System (13)
 Pressure (between STR15 to 16)
 Hyd Pipe 0.5 OD Blue System (14)
 Return (between STR14 to 15)

 Scavenge Jet Pumps Supply Pipe (15)
 NA Valve-Float Vent (L & R) (16)
 O to 750 (1653) RIB-15 Interfaces (Joints) (17)

 NOTE : In the work step titles that follow an AIRBUS (Single
____ Aisle Aircraft) drawing (DWG) reference is given. These can supply more specific data, if required. You can get them from Airbus OnLine Services (AOLS).
 (2) The Intercell Transfer Valve (ICTV) Installation at Rib 15 (Ref. DWG D28250002)
 (a) Get access to each (of the two) related ICTV installations on each side of the Rib 15 (Ref. AMM TASK 28-15-51-000-001) and (Ref. AMM TASK 28-15-51-000-002).
 「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1R EFF : 001-049, 051-099, 101-149, 151-199, ∞∞28-15-00∞∞∞∞∞∞∞∞∞∞Page 255
 201-299, 401-499, Aug 01/05 CES

 (b) Physically examine the two related ICTV installations. 1 Make sure that the O-rings (between each ICTV valve and the
_ Rib 15) are installed correctly. If necessary, remove each valve to check (Ref. AMM TASK 28-15-51-000-001) (Ref. AMM TASK 28-15-51-400-001) and (Ref. AMM TASK 28-15-51-000-002) (Ref. AMM TASK 28-15-51-400-002).
 2 Make sure that the sealant for each of the ICTV four
_ attachment bolts was applied correctly and is in good condition. If necessary, re-apply the sealant.
 (c) Do the test given in Para. 3.D.
 (3) The Recirculation Cooling System Fuel Return Pipe Installation at Rib 15 (Ref. DWG D28250004)
 (a) Physically examine the fuel-pipe connector installations on each side of the Rib 15.
 1 Make sure that the O-rings (between each connector and the Rib
_ 15) are installed correctly. If necessary, remove the connectors to check the installation is serviceable.
 2 Make sure that the sealant for each of the four attachment
_ bolts was applied correctly and is in good condition. If necessary, re-apply the sealant.
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320 Trouble Shooting Manual 排故手冊 FUEL 燃油1(43)