- more maintenance steps are not necessary.

 (3) If the related engine LP fuel supply line does not operate as specified or this is the second/subsequent failure:

 - go to Para. 4.
R **ON A/C 301-399,
R A. Prerequisite Test
R NOTE : If there are any failed LRUs in the FLSS, this test is necessary
____ R to find and to show them. This is because the FLSS Bite test is R only done when the aircraft is electrically powered up and the
 「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞28-21-00∞∞∞∞∞∞∞∞∞∞Page A277
 May 01/04 CES

R FLSS defect report transferred to the Post Flight Report (PFR) at
R take off.
R
R If a FLSS LRU is unserviceable and causes the fuel to be used in
R the incorrect sequence, the FQIC will issue (at all times
R excluding refuel):
R - inputs to the FWC to show the FUEL-AUTO TRANSFER FAULT warning
R - a ground to the P/BSW-FUEL/CTR TK/MODE SELECT/AUTO (4QL) to
R light the FAULT legend if set to AUTO.
R
R This procedure is based on actual aircraft malfunctions:
R - that did not give any reported WARNINGS or MESSAGES on the PFR
R - where the fuel imbalance was seen by the flight crew before a
R FUEL imbalance advisory was given.

R (1) Do the FLSS BITE Test (Ref. AMM TASK 28-46-00-740-001).

R (2) Examine the FLSS STATUS page for any of the FUEL LEVEL SENSING
R messages that follow:
R - L(R) FULL SENSOR 23QJ1(2)
R - L(R) UNFULL SENSOR 24QJ1(2)
R - L(R) UNFULL SENSOR 25QJ1(2)
R - L(R) UNFULL SENSOR 26QJ1(2)
R - L(R) FULL SENSOR 27QJ1(2)
R - L(R) SURGE SENSOR 28QJ1(2)

R NOTE : If a surge tank sensor becomes wet during normal operation it

____ R will cause the ECAM warning FUEL L(R) WING TK OVERFLOW and the R applicable flight crew instructions to be given.
R - FLSCU1(2) 7(9)QJ.
R (3) If none of the messages given in step (2) are shown, go to the R Operational Test in Para. 3.B.
R (4) If one or more of the messages given in step (2) are shown:
R (a) Go to (Ref. TSM 28-CFDS PB 101) for the applicable Task(s) R number(s).
R (b) Trouble shoot the applicable LRU(s) shown.
R (c) Go to the Operational Test in Para. 3.B.
R B. Operational Test
R (1) Go to the Operational Leak Test of the Air Release Valve Float (Ref. R AMM TASK 28-21-00-710-011).
R NOTE : The engine feed system (internal to the collector cell) has a
____ R suction valve with a controlled leak rate when in the closed R position.
 「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1R EFF : 301-399, ∞∞28-21-00∞∞∞∞∞∞∞∞∞∞Page A278
 May 01/04 CES

R The suction valve has a number of slots in the valve seat.
R These slots let fuel go (escape from) between the clack valve
R and the valve seat. The fuel flow generated through the slots
R (controlled leak) is to prevent the formation of ice in the
R mouth of the suction valve. This is necessary because a
R proportion of water can be in the fuel.
R The maximum permitted flow of the controlled leak is 210 kg
R (460 lb)/hour.

R (a) If the left side fuel quantity was more than the right side (or
R fuel was discharged from the left side NACA vent):
R - do the AMM TASK with the R PUMP-FUEL No. 1 (22QA).

R NOTE : During this test procedure fuel from the right wing tank

____ R is pressurized by the R PUMP-FUEL No. 1 (22QA). This fuel R pressure is then applied (through the open crossfeed R valve) to the ENG 1 (aircraft left side) LP fuel supply R line to test for a leak.
R (b) If the right side fuel quantity was more than the left side (or
R fuel was discharged from the right side NACA vent):
R - do the AMM TASK with the L PUMP-FUEL No. 1 (21QA).

R NOTE : During this test procedure fuel from the left wing tank is

____ R pressurized by the L PUMP-FUEL No. 1 (21QA). This fuel R pressure is then applied (through the open crossfeed R valve) to the ENG 2 (aircraft right side) LP fuel supply R line to test for a leak.
R (2) If this is the first time this failure occurred and the related
R engine LP fuel supply line operates as specified:
R - more maintenance steps are not necessary.

R (3) If the related engine LP fuel supply line does not operate as
R specified or this is the second/subsequent failure:
R - go to Para. 4.

R **ON A/C ALL

 4. Fault Isolation
_______________
 A. Procedure
 (1) Replace the VALVE-AIR RELEASE, L WING TK (86QM) (VALVE-AIR RELEASE, R WING TK (87QM)) (Ref. AMM TASK 28-21-41-000-001) and (Ref. AMM TASK 28-21-41-400-001).
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320 Trouble Shooting Manual 排故手冊 FUEL 燃油1(145)