- the terminal X2, RELAY-R WING TK LOW LEVEL CHANNEL A (8QP) and the terminal B, RELAY-L OR R FWD XFR VALVE OPEN LATCH (14QP)
- the terminal 1, RELAY-L OR R FWD OPEN LATCH (14QP) and the pin 11B, connector AA, FLSCU-2 (9QJ)
- the terminal 3, RELAY-L OR R FWD OPEN LATCH (14QP) and the pin 11B, connector AA, FLSCU-1 (7QJ)
- the pin 1C, connector AA, FLSCU-1 (7QJ) and the C/B-FUEL/XFR VALVE 2/WING/R (4QP)
- the pin 1C, connector AA, FLSCU-2 (9QJ) and the C/B-FUEL/XFR VALVE 2/WING/L (3QP).
(14) Repair all the unserviceable wiring and connectors.
(15) Do the test given in Para 3.B.
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1R EFF : 001-049, 051-099, 101-149, 151-199, ∞∞28-15-00∞∞∞∞∞∞∞∞∞∞Page 232
201-299, 401-499, Aug 01/05 CES TASK 28-15-00-810-810
Intercell XFR Valve Failure (Right Rear) - Open When Fuel Not Low Level
WARNING : OBEY THE FUEL SAFETY PROCEDURES.
_______
WARNING : WHEN YOU DO WORK ON THE FUEL SYSTEM WIRING, YOU MUST USE TEST
_______ EQUIPMENT THAT IS APPROVED (REFER TO INTERNATIONAL OR NATIONAL SPECIFICATIONS FOR INTRINSICALLY SAFE TEST EQUIPMENT, E.G. EN50-020, UL913 OR EQUIVALENT). TEST EQUIPMENT THAT IS NOT APPROVED CAN CAUSE FIRE OR AN EXPLOSION.
1. Possible Causes
_______________
- ACTUATOR-TRANSFER VALVE, R REAR SPAR (12QP)
- aircraft wiring
- RELAY-L WING TK LOW LEVEL CHANNEL A (5QP) 103VU
- RELAY-R WING TK LOW LEVEL CHANNEL B (6QP) 103VU
- RELAY-L OR R REAR XFR VALVE OPEN LATCH (13QP) 103VU
2. Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific multimeter
B. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
ESPM 20-00-00 AMM 28-15-00-740-002 Functional (BITE) Test of the Intercell Transfer
Valves
AMM 28-15-51-000-002 Removal of the Actuator 11QP(12QP)
AMM 28-15-51-400-002 Installation of the Actuator 11QP(12QP)
AMM 28-46-00-740-001 Functional (BITE) Test
ASM 28-15/01
TFU 28.15.00.003
TSM INTRO, 3.G(2)(b)2_
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1R EFF : 001-049, 051-099, 101-149, 151-199, ∞∞28-15-00∞∞∞∞∞∞∞∞∞∞Page 233
201-299, 401-499, Aug 01/05 CES 3. Fault Confirmation
__________________
A. Table of the circuit breakers used in this procedure:
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU FUEL/FQI/CHAN/1 1QT A13 121VU FUEL/FQI/CHAN/2 2QT M27
B. Test
(1) Read the:
(a) Paragraph titled Intermittant fault (Ref. TSM INTRO, 3.G(2)(b)2_).
(b) Technical Follow-Up (Ref. TFU 28.15.00.003).
(2) Do the Functional BITE Test (of the FLSS) (Ref. AMM TASK 28-46-00-740-001).
(a) Examine the FLSS STATUS page. Look for one (or more) of the messages that follow:
- L LO LEVEL SENSOR 16QJ1
- R LO LEVEL SENSOR 15QJ2
- FLSCU1 7QJ
- FLSCU2 9QJ.
(b) If a message(s) listed (in the step before):
- is not shown, do step (3)
- is shown, trouble shoot the LRU(s) before you do step (3). Refer to the Fault Symptoms List/28-CFDS for the related Task number.
(3) Do the Functional BITE Test of the Intercell Transfer Valves (Ref. AMM TASK 28-15-00-740-002).
NOTE : The COMMAND FLSS BITE option does not test the intercell
____
transfer valves (ICTVs).
NOTE : The ICTVs are motor driven and the electrical power for these
____ circuits is supplied from 801PP, 28VDC, ESS BUS/SHEDDABLE (Ref. ASM 28-15/01). The ICTVs will not operate on battery power.
(a) Examine the FLSS STATUS page. Look for the (left wing rear ICTV) message XFR VALVE 30QM/73QM/12QP.
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1R EFF : 001-049, 051-099, 101-149, 151-199, ∞∞28-15-00∞∞∞∞∞∞∞∞∞∞Page 234
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320 Trouble Shooting Manual 排故手冊 FUEL 燃油1(34)
