(c) In accordance with the local regulations:
1 Remove all the spilt fuel.
_ 2 Clean the fuel spillage from the area on the ground (hard
_
standing).
(d) Examine the holes in the drain mast to find which hole the fuel comes from.
NOTE : The top hole is from the APU shrouded fuel-feed line.
____ The bottom hole is from the center tank ventilation area.
(e) Look for signs of fuel leakage in the areas that follow: NOTE : The fuel leakage can be caused by incorrect assembly,
____ damage, the natural deteriation of fuel sealant or an unserviceable seal.
1 The main under carriage bays.
_
2 The center tank.
_
(f) If a fuel leak is found, repair all the leaks:
- (Ref. AMM TASK 51-76-12-300-001)
- (Ref. AMM TASK 51-76-12-300-002)
- (Ref. SIL 57-0086).
(g) Continue with step (3).
(3) Do the procedure Check Fuel Leak Monitor 500QM (center tank) for Evidence of Fuel Leakage (Ref. AMM TASK 28-11-00-200-002).
(4) If:
(a) No fuel is found in the fuel leak monitor 500QM (center tank), troubleshoot the APU fuel-feed line as follows:
NOTE : The logic for step (a) is.
____ The APU fuel-feed line does not have a leak monitor, if the leak monitor 500QM does not show fuel, the source must be the APU shrouded fuel-feed line.
1 Do a Leak Test of the APU Fuel Line:
_ a Do an operational test of the APU fuel pump system to purge
_ the fuel line (Ref. AMM TASK 28-22-00-710-001).
b Do the leak test of the APU fuel line (Ref. AMM TASK 28-22-
_ 00-790-002) or if applicable (Ref. AMM TASK 28-22-00-210-001).
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞28-13-00∞∞∞∞∞∞∞∞∞∞Page 202
Nov 01/02 CES
c Examine the APU Fuel Line for leaks.
_
NOTE : Leaks are not permitted.____
d_ If you find leaks, replace the items of the fuel line, as
necessary (Ref. AMM TASK 28-22-47-000-001) and (Ref. AMM
TASK 28-22-47-400-001).
(b) Fuel is found in the leak monitor 500QM (center wing box), do (Ref. TASK 28-11-00-810-801).
4. Fault Isolation
_______________
A. Procedure
(1) Not applicable
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞28-13-00∞∞∞∞∞∞∞∞∞∞Page 203
Nov 01/02 CES
INTERCELL TRANSFER - FAULT ISOLATION PROCEDURES
_______________________________________________
TASK 28-15-00-810-801
Intercell XFR System Failure (Left Wing) - Both Valves Remain Shut At Fuel Low
Level
WARNING : OBEY THE FUEL SAFETY PROCEDURES.
_______
1. Possible Causes
_______________
- Left Wing Forward Intercell XFR VALVE (27QM/70QM/9QP)
- Left Wing Rear Intercell XFR VALVE (28QM/71QM/11QP)
2. Job Set-up Information
______________________
A. Referenced Information
-------------------------------------------------------------------------------
REFERENCE DESIGNATION
-------------------------------------------------------------------------------
28-15-00-810-803 Intercell XFR VALVE 27QM/70QM/9QP (Left Forward) Fault - Stays Closed When The Fuel In The Inner-cell Is At Low Level
28-15-00-810-804 Intercell XFR Valve 28QM/71QM/11QP (Left Rear) Fault
- Stays Closed When The Fuel In The Inner-cell Is At
Low Level
AMM 28-46-00-740-001 Functional (BITE) Test
3. Fault Confirmation
__________________
A. Table of the circuit breakers used in this procedure:
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU FUEL/FQI/CHAN/1 1QT A13 121VU FUEL/FQI/CHAN/2 2QT M27
B. Do the FLSS BITE Test (Ref. AMM TASK 28-46-00-740-001).
NOTE : If the aircraft is already supplied with electrical power, reset
____ the FQIC. (Open, then after 5 seconds, close the two C/Bs 1QT and 2QT). The FLSS BITE test is carried out once a short time after power up. After a two minute delay to allow the FQIC to do the BITE test, continue.
NOTE : The intercell transfer valves (ICTVs) are not tested by the
____ COMMAND FLSS BITE option. (This option only available with 07 FQIC Software Standard).
中國航空網(wǎng) m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320 Trouble Shooting Manual 排故手冊 FUEL 燃油1(20)
