- if the wiring/connectors are OK, do step (9)
- if a repair is done, do the next step
(8) Do the test in Para. 3.A.:
- if the fault continues, do the next step.
(9) Replace SFCC-2 (22CV) (Ref. AMM TASK 27-51-34-000-001) and (Ref. AMM TASK 27-51-34-400-001).
(10) Do the test given in Para. 3.A.
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1R EFF : 001-049, 051-099, 101-149, 151-199, ∞∞28-21-00∞∞∞∞∞∞∞∞∞∞Page A259
201-299, 401-499, Aug 01/05 CES
TASK 28-21-00-810-820
Fuel Pumps - Center Tank Autofeed Failure (Pumps Do Not Stop At CTR TK Low Fuel Level)
WARNING : OBEY THE FUEL SAFETY PROCEDURES.
_______
WARNING : WHEN YOU DO WORK ON THE FUEL SYSTEM WIRING, YOU MUST USE TEST
_______ EQUIPMENT THAT IS APPROVED (REFER TO INTERNATIONAL OR NATIONAL SPECIFICATIONS FOR INTRINSICALLY SAFE TEST EQUIPMENT, E.G. EN50-020, UL913 OR EQUIVALENT). TEST EQUIPMENT THAT IS NOT APPROVED CAN CAUSE FIRE OR AN EXPLOSION.
1. Possible Causes
_______________
- RELAY-CTR TK AUTO CONTROL, PUMP 1(2) 41QA(42QA) 92VU
2. Job Set-up Information
______________________
A. Referenced Information
-------------------------------------------------------------------------------
REFERENCE DESIGNATION
-------------------------------------------------------------------------------
28-21-00-810-813 Fuel Pumps - Center Tank Fuel Pump No. 1 (Left Side) 37QA System Malfunction 28-21-00-810-814 Fuel Pumps - Center Tank Fuel Pump No. 2 (Right Side) 38QA System Malfunction 28-21-00-810-817 Fuel Pumps - Center Tank Fuel Pump No. 1 (Left Side) Contactor Control Failure (Manual Control) 28-21-00-810-818 Fuel Pumps - Center Tank Fuel Pump No. 2 (Right Side) Contactor Control Failure (Manual Control) AMM 28-21-00-720-001 Functional Test of the Center-Tank Fuel Control
3. Fault Confirmation
__________________
A. Do the Functional Test of the Center-Tank Fuel Control (in manual and auto control modes) (Ref. AMM TASK 28-21-00-720-001).
4. Fault Isolation
_______________
A. If the:
(1) Center-Tank Fuel Pump No 1 does not operate correctly in the Manual Mode do:
(a) Fuel Pumps - Center Tank Pump-Fuel No 1 System Failure (Ref. TASK 28-21-00-810-813).
(b) Fuel Pumps - Center Tank Pump-Fuel No 1 Contactor Control Failure (Ref. TASK 28-21-00-810-817).
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1R EFF : 001-049, 051-099, 101-149, 151-199, ∞∞28-21-00∞∞∞∞∞∞∞∞∞∞Page A260
201-299, 401-499, Aug 01/05 CES
(2) Center-Tank Fuel Pump No 2 does not operate correctly in the Manual Mode do:
(a) Fuel Pumps - Center Tank Pump-Fuel No 2 System Failure (Ref. TASK 28-21-00-810-814).
(b) Fuel Pumps - Center Tank Pump-Fuel No 2 Contactor Control Failure (Ref. TASK 28-21-00-810-818).
(3) If a pump does not stop during the test given in Para. 3.A., Auto Mode:
- examine the ECAM FUEL System Display page to see which side(s) has/have not shut off correctly.
NOTE : The CTR TANK PUMPS INDICATIONS are:
____
- In line - Green - Pump pressure normal (pump contactor on)
- LO - Amber - Pump low pressure (pump contactor on)
- Cross line - Green - Pump contactor off and auto shut off required
- Cross line - Amber - Pump contactor off and auto shut off not required.
NOTE : For the ECAM warning/caution - AUTO FEED FAULT to have been
____ generated by the FWC, a CTR TK PUMP 1 or 2 AUTO SHUT OFF REQUIRED signal has been received. This shows that:
- the FLSCU-1(2) input of fuel low level (a ground) is correct
- the diodes are conducting correctly
- the RELAY 45QA(46QA) has operated correctly (energized)
- the RELAY 41QA(42QA), contacts C to 6 (the source of the AUTO SHUT OFF REQUIRED signal) have operated correctly (energized).
(4) If the fault continues:
- do a check of the RELAY-CTR TK AUTO CONTROL, PUMP 1(2) 41QA(42QA) 92VU (contacts B to 3) and replace if necessary.
(5) Do the test given in Para. 3.A.
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1R EFF : 001-049, 051-099, 101-149, 151-199, ∞∞28-21-00∞∞∞∞∞∞∞∞∞∞Page A261
201-299, 401-499, Aug 01/05 CES
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320 Trouble Shooting Manual 排故手冊 FUEL 燃油1(137)
