-------------------------------------------------------------------------------ACTION RESULT -------------------------------------------------------------------------------
-Close the floppy disk access
door.
3. On the DLS. On the DLS display:
-Push the SEL CTL key. - The AIDS NOT SELECTED indication shows.
-Set the ON/OFF switch to OFF. R **ON A/C 001-049, 051-099, 101-105, 155-199, 201-202, 208-210,
5. Close-up
________ R **ON A/C 001-049, 051-099, 101-105,
Subtask 31-36-00-860-075
A. Put the system back to the serviceable condition.
(1)
De-energize the aircraft electrical circuits
(Ref. TASK 24-41-00-862-002)
(2)
Disconnect the Adapter Cable from the DMU.
(3)
Disconnect the Adapter Cable from the PDL.
(4) On the DMU close the access door.
**ON A/C 155-199, 201-202, 208-210,
Subtask 31-36-00-860-075-A
A. Put the system back to the serviceable condition.
(1) De-energize the aircraft electrical circuits
(Ref. TASK 24-41-00-862-002)
R 1EFF : 001-049, 051-099, 101-105, 155-199, 1 31-36-00Page 297 1201-202, 208-210, 1May 01/05 1 1 1CES 1R **ON A/C 001-049, 051-099, 101-105,
Subtask 31-36-00-410-064
B. Close Access
(1)
Make sure that the work area is clean and clear of tool(s) and other items.
(2)
Close the access door 824. (Ref. TASK 52-41-00-410-002)
(3) Remove the access platform(s).
**ON A/C 155-199, 208-210,
Subtask 31-36-00-410-064-A
B. Close Access
(1) Make sure that the work area is clean and clear of tool(s) and other items.
R 1EFF : 001-049, 051-099, 101-105, 155-199, 1 31-36-00Page 298 1208-210, 1May 01/05 1 1 1CES 1R **ON A/C 106-149, 211-299, 301-399, 401-499,
TASK 31-36-00-710-014
Dump Procedure to Download FDIMU Data
1. Reason for the Job
__________________
This procedure contains the download of SAR- or REPORT-files, which are stored in the non-volatile Solid-State Mass Memory (SSMM).
2. Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific Adapter Cable
No specific Disk
No specific PDL
No specific access platform 1.6 m (5 ft. 3 in.)
B. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
24-41-00-861-002 Energize the Aircraft Electrical Circuits from the External Power 24-41-00-862-002 De-energize the Aircraft Electrical Circuits Supplied
from the External Power 52-41-00-010-002 Open the Avionics Compartment Doors for Access 52-41-00-410-002 Close the Avionics Compartment Doors after Access
R 1EFF : 106-149, 211-299, 301-399, 401-499, 1 31-36-00Page 299 1 1 Aug 01/05 1 1 1CES 1
3. Job Set-up
__________ Subtask 31-36-00-010-069
A. Get Access
(1) Put the access platform in position at the access door 824 in zone
128.
(2)
Open the access door 824 (Ref. TASK 52-41-00-010-002). Subtask 31-36-00-860-095
B.
Aircraft Maintenance Configuration (PDL)
NOTE : This task is only applicable for data download via the PDL.
____
NOTE : For the download procedure a 1,44 MB formatted 3,5 inch disk is
____ necessary. This disk must be prepared by the GSE Application Software. Refer to the software vendor documentation.
(1)
Energize the aircraft electrical circuits
(Ref. TASK 24-41-00-861-002)
(2)
On the frontpanel of the FDIMU, open the flap to get access to the FDIMU front connector.
(3)
On the Portable Data Loader (PDL) make sure that the ON/OFF switch is in the OFF position.
(4)
Connect the Adapter Cable to the FMI front connector.
(5)
Connect the Adapter Cable to the PDL interface.
(6)
Make sure that the Disk is not write-protected. Subtask 31-36-00-860-097
C.
Aircraft Maintenance Configuration (MDDU)
NOTE : This task is only applicable for data download via the MDDU.
____
NOTE : For the download procedure a 1,44 MB formatted 3,5 inch disk is
中國航空網(wǎng) m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM 指示/記錄系統(tǒng) 4(17)
