-------------------------------------------------------------------------------ACTION RESULT -------------------------------------------------------------------------------
3.
Open, safety clip and tag C/B 4QP
4.
Remove the safety clip and the tag and close C/B 4QP
5.
Open, safety clip and tag C/B 2QP
6.
Remove the safety clip and the tag and close C/B 2QP
7.
Open, safety clip and tag C/B 1QP
8.
Remove the safety clip and the tag and close C/B 1QP
5. Close-up
________ Subtask 28-40-00-860-055On the ECAM DU:
-
make sure that the left-wing outer-cell fuel content decreases and the left- wing inner-cell fuel content increases.
On the ECAM DU:
-
make sure that the fuel transfer stops.
On the ECAM DU:
-
make sure that the left-wing outer-cell fuel content decreases and the left- wing inner-cell fuel content increases.
On the ECAM DU:
-
make sure that the fuel transfer stops.
On the ECAM DU:
-
make sure that the right-wing outer-cell fuel content decreases and the right- wing inner-cell fuel content increases.
On the ECAM DU:
-
make sure that the fuel transfer stops.
A. Aircraft Maintenance Configuration
(1)
On the panel 800VU:
-set the MODE SELECT switch to the OFF position.
(2)
Do the EIS stop procedure (Ref. TASK 31-60-00-860-002).
R 1EFF : 001-049, 051-099, 101-149, 151-199, 1 28-40-00Page 428 1201-299, 401-499, 1Aug 01/05 1 1 1CES 1 Subtask 28-40-00-410-054
B. Close Access
(1) Make sure that the work area is clean and clear of tool(s) and other items.
(2) Close the access door 192MB. Subtask 28-40-00-650-053
C. Fuel Configuration
(1) Refuel, defuel or transfer fuel as necessary (Ref. TASK 12-11-28-650-003), (Ref. TASK 28-25-00-650-001), (Ref. TASK 28-25-00-869-001).
Subtask 28-40-00-862-053
D. De-energize the Electrical Circuits
(1) De-energize the aircraft electrical circuits (Ref. TASK 24-41-00-862-002).
Subtask 28-40-00-942-058
E. Removal of Equipment
(1)
Remove the safety barriers.
(2)
Remove the ground support and maintenance equipment, the special and standard tools and all other items.
R 1EFF : 001-049, 051-099, 101-149, 151-199, 1 28-40-00Page 429 1201-299, 401-499, 1Aug 01/05 1 1 1CES 1R **ON A/C ALL
TASK 28-40-00-040-009
Engine LP Valve Indication - When ECAM Display Inoperative
WARNING : PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU
_______
START A TASK ON OR NEAR:
-
THE FLIGHT CONTROLS
-
THE FLIGHT CONTROL SURFACES
-
THE LANDING GEAR AND THE RELATED DOORS
-COMPONENTS THAT MOVE.
WARNING : MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING
_______
GEAR.
1. Reason for the Job
__________________
Refer to the MMEL TASK: 28-40-06-B)
Indications on ECAM FUEL page
Engine LP valve indication
Engine LP Valve Indication - When ECAM Display Inoperative
2. Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific circuit breaker(s) safety clip(s)
No specific safety barriers
No specific warning notice
No specific access platform 3.2 m (10 ft. 6 in.)
1EFF : ALL 1 28-40-00Page 430 1 1 May 01/04 1 1 1CES 1
B. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
24-41-00-861-002 Energize the Aircraft Electrical Circuits from the External Power 24-41-00-862-002 De-energize the Aircraft Electrical Circuits Supplied
from the External Power 27-80-00-866-004 Extending the Slats on the Ground 28-00-00-910-001 Fuel Safety Procedures 57-41-37-000-003 Removal of the Access Panel 522AT(622AT) 57-41-37-400-003 Installation of the Access Panel 522AT(622AT) 28-40-00-991-003 Fig. 402 28-40-00-991-004 Fig. 403
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM FUEL 燃油4(161)
