(4)
Close the access door 315AL.
(5) Remove the access platform(s). Subtask 28-29-41-650-052
B. Refuel the center tank (Ref. TASK 12-11-28-650-003).
1EFF : ALL 1 28-29-41Page 409 1 1 Feb 01/98 1 1 1CES 1 ACTUATOR - APU FUEL LP VALVE (3QF) - REMOVAL/INSTALLATION
_________________________________________________________
TASK 28-29-51-000-001
Removal of the APU Fuel LP Valve Actuator (3QF)
WARNING : OBEY THE FUEL SAFETY PROCEDURES.
_______
1.
Reason for the Job
__________________
Self Explanatory
2.
Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------
REFERENCE QTY DESIGNATION
-------------------------------------------------------------------------------
No specific blanking caps No specific circuit breaker(s) safety clip(s) R No specific stepladder 2 m (6 ft. 7 in.) R No specific 1 WARNING NOTICE
B. Referenced Information
-------------------------------------------------------------------------------
REFERENCE DESIGNATION
-------------------------------------------------------------------------------
28-00-00-910-001 Fuel Safety Procedures
32-12-00-010-001 Open the Main Gear Doors for Access
28-29-51-991-001 Fig. 401
3. Job Set-up
__________
Subtask 28-29-51-941-050
A. Safety Precautions
(1)
When you do maintenance work on the fuel system you must obey the fuel safety procedures (Ref. TASK 28-00-00-910-001).
(2)
On the APU section of the overhead panel 25VU, make sure that the APU MASTER SW is in the off position (the ON legend is off).
1EFF : ALL 1 28-29-51Page 401 1 1 Aug 01/04 1 1 1CES 1
(3) On the FUEL overhead panel 40VU, make sure that all L TK PUMPS and R TK PUMPS pushbutton switches are released (the OFF legends are on).
R (4) Put the WARNING NOTICE in position: - on the overhead panel 25VU, to tell persons not to operate the APU MASTER SW; - on the FUEL panel 40VU, to tell persons not to operate the fuel system; - on the APU FIRE panel 20VU, to tell persons not to operate the fire extinguishing system.
Subtask 28-29-51-865-050
B. Open, safety and tag this(these) circuit breaker(s):
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU APU/FUEL/BLOW OFF/PUMP 2QC B14 121VU APU/FUEL/BLOW OFF/CTL 1QC K39 121VU APU/APU/CTL 2KD L42 121VU APU/ECB/SPLY 1KD L41 121VU APU/FUEL/LP VALVE/CTL 1QF M40 121VU APU/FUEL/LP VALVE/SPLY 2QF M39 121VU APU/FUEL/PUMP/CTL 3QC M38
Subtask 28-29-51-010-050
C. Get Access
(1)
Open the left MLG door (Ref. TASK 32-12-00-010-001).
(2)
Put the stepladder in position at the MLG bay.
1EFF : ALL 1 28-29-51Page 402 1 1 Aug 01/04 1 1 1CES 1
4. Procedure
_________ R (Ref. Fig. 401/TASK 28-29-51-991-001) Subtask 28-29-51-020-050
A. Removal of the LP Valve Actuator NOTE : The Actuator P/N: B27000 and the Actuator P/N: A08000 together
____ with the Adaptor P/N: A08900 are 2 way interchangeable.
(1)
Actuator (P/N: B27000)
(a)
Disconnect the electrical connectors (2) from the APU fuel LP valve actuator (1).
(b)
Put blanking caps on the disconnected electrical connectors.
(c)
Remove the self-locking nuts (3) and the washers (4).
(d)
Remove the bonding strap (5) from the mounting stud.
(e)
Remove the APU fuel LP valve actuator (1) from the mounting studs.
(f)
Remove and discard the o-ring (6) from the APU LP Valve Actuator.
(2)
Actuator (P/N: A08000) from Adaptor (P/N: A08900)
(a)
Disconnect the electrical connectors (2) from the APU fuel LP valve actuator (1).
(b)
Put blanking caps on the disconnected electrical connectors.
(c)
Remove the self locking nut (3) and the washer (4) and remove the bonding strap (5) from the adaptor (7).
(d)
Remove the clamp (6) and remove the APU fuel LP valve actuator
(1)
from the adaptor.
(3)
Adaptor (P/N: A08900)
(a)
Remove the self-locking nuts (3) and the washers (4).
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM FUEL 燃油4(149)
