A. Close Access
 (1)
 Make sure that the work area is clean and clear of tool(s) and other items.

 (2)
 Close the access door 312AR.

 (3)
 Remove the access platform.

 1EFF : ALL 1 23-71-35Page 414 1 1 Aug 01/05 1 1 1CES 1 ANTI HIJACK CAMERA MONITORING - DESCRIPTION AND OPERATION

_________________________________________________________
 **ON A/C 216-216,
 Post SB 23-1208 For A/C 216-216,
 1.
 General

_______ The Cockpit Door Surveillance System (CDSS) uses cameras in the cockpit entrance, and left and right door 1 areas. They let the flight crew monitor the door 1 area and identify persons who request access to the cockpit.

 2.
 Component Location

__________________ R (Ref. Fig. 001)
R -------------------------------------------------------------------------------R FIN | FUNCTIONAL DESIGNATION | PANEL|ZONE|ACCESS | ATA R | | | | DOOR | REF. R -------------------------------------------------------------------------------R 12RA CAMERA-COCKPIT DOOR 210 23-72-51 R 13RA CAMERA-DR 1, LH 224 23-72-51 R 14RA CAMERA-DR 1, RH 223 23-72-51
 3. System Description
__________________ R (Ref. Fig. 002)
R A. The Cockpit Door Surveillance System has the following components:
R - 3 Cameras
R - 1 LCD (with a system controller)
R - 1 CKPT DOOR VIDEO switch
R - 1 VIDEO pushbutton.

R (1) Cameras
R Three cameras are installed in the ceiling panels in the cockpit
R entrance and the door 1 area.
R - Camera 1 is installed above the cockpit door. It gives pictures of
R the area directly in front of the cockpit door.
R - Camera 2 is installed in the ceiling of the right door 1 area. It
R gives pictures of the area directly below camera 2 in the right
R door 1 area
R - Camera 3 is installed in the ceiling of the left door 1 area. It
R gives pictures of the area directly below camera 3 in the left door
R 1 area.

 1EFF : 216-216, 1 23-72-00Page 1 1 1 Aug 01/04 1 1 1CES 1

 Cockpit-Door Surveillance-System
 Figure 001
 1EFF :  216-216,  1  23-72-00 Page 2 
1  1  May 01/03
 1  1
 1CES  1

 Cockpit-Door Surveillance-System
 Figure 002
 1EFF :  216-216,  1  23-72-00 Page 3 
1  1  May 01/03
 1  1
 1CES  1

R  (2) LCD (10RA) 
R  The LCD is installed on the aft wall of the cockpit. It lets the 
R  flight crew see the picture from the cameras. 
R  The pictures from camera 1 are shown as a full screen on the LCD and 
R  the pictures from camera 2 and 3 are shown as a split screen. The 
R  pictures from camera 2 are shown left of the LCD screen and the 
R  pictures from camera 3 are shown on right. 
R  If the system gets no signal from the VIDEO push button (16RA) or the 
R  ENTRY REQUEST KEYPAD (Ref. 52-51-00) for 5 minutes the LCD 
R  automatically goes into the standby/power save mode (blank screen). 
R  NOTE : You can change the pin priority to make the screen stay on____ 
R  continiously. 
R  If entry is requested with the keypad (screen is in the standby 
R  mode), the screen automatically comes on and shows the picture from 
R  camera 1. If entry is requested again before 30 seconds after the 
R  last-entry-request the signals are inhibited. This is to let the 
R  pilot use the VIDEO pushbutton to select and see the pictures from 
R  camera 1 or cameras 2 and 3. 
R  If the VIDEO pushbutton is pushed during the first 120 seconds of the 
R  standby/power save mode, the last shown pictures come on. 
R  If the VIDEO pushbutton is pushed after the first 120 seconds of the 
R  standby/power save mode, the picture for camera 1 comes on. 
R  (3) CKPT DOOR VIDEO Switch (17RA) 
R  The CKPT DOOR VIDEO switch is installed on the overhead panel 27VU. 
R  It sets the CDSS on or off. The switch has an OFF legend which is on 
R  when the system is off and off when the system is on. 
R  (4) VIDEO Push Button (16RA) 
R  The VIDEO push button is installed on the pedestal, on panel 119VU. 
R  It lets the flight crew select between the pictures from camera 1 and 
R  from cameras 2 and 3.
 4. Power Supply____________
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM Communications 通訊3(31)