曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

gradient one engine inoperative required by the regulations is 2.1 % at a speed not exceeding 1.4
Vs. This requirement is also called approach climb performance by regulations.
The following pages allow to determine the go around limiting weight which satisfies the required
gradient with the certified go around configurations 3 and 2.
The required gradient of 2.1 % is considered at the airport reference altitude. The power setting
is “GO AROUND” thrust with the air conditioning ON. The speed is 1.23 Vs of the specified
configuration. For the occasional cases where approach climb performance is found restrictive, a
correction is given for an increased speed, up to 1.4 Vs.
Note: Landing climb performance (2 engines running) is never limiting.
GENERAL
Applicable to:
, ,
MSN,,
In the go around configuration corresponding to the all engine procedure, the minimum steady
gradient one engine inoperative required by the regulations is 2.1 % at a speed not exceeding 1.4
Vs. This requirement is also called approach climb performance by regulations.
The following graph allow to determine the go around limiting weight which satisfies the required
gradient with the certified go around configurations 3 and 2.
The required gradient of 2.1 % is considered at the airport reference altitude. The power setting
is “GO AROUND” thrust with the air conditioning ON. The speed is 1.23 Vs of the specified
configuration. For the occasional cases where approach climb performance is found restrictive, a
correction is given for an increased speed, up to 1.4 Vs.
Note: Landing climb performance (2 engines running) is never limiting.
PROCEDURE
Applicable to: MSN,
4473
According to airport pressure altitude and temperature determine if the slats/flaps setting must be
restricted as a function of the landing weight, in order to meet the go around gradient requirement of
2.1 %.
Establish the final approach configuration with one more step of flaps. If the approach is interrupted,
retract the flaps by one step during the go-around.
A318/A319/A320/A321 FLIGHT CREW
OPERATING MANUAL
PERFORMANCE
GO AROUND
GENERAL
A318/A319/A320/A321 FLEET PER-GOA-GEN P 2/4
FCOM 19 AUG 10
In case of category II approach, JAR-OPS requires a regulatory approach climb gradient of 2.5 % to
be maintained.
Use the tables for CAT II approach to determine the maximum approach climb limiting weight
according to airport pressure altitude and temperature.
Note: 1. If circumstances dictate, landing may be made at a weight corresponding to the
maximum structural takeoff weight. (Refer to STLO-ABN-80 OVERWEIGHT LANDING).
2. When icing conditions are predicted during the flight and TAT is 10 °C or below and there
is an evidence of significant ice accretion, to take into account ice formation on the non
heated structure :
decrease the approach ‐ climb limiting weight by 4.5 %.
‐ in CONF FULL, the approach speed must not be lower than VREF +5 kt and the
landing distance must be multiplied by 1.1.
or
in CONF 3, the approach speed must not be lower than VLS +10 kt and the landing
distance must be multiplied by 1.15.
3. In the following tables corrections for anti ice are only valid for OAT lower than 10 °C.
PROCEDURE
Applicable to:
, ,
MSN,,
According to airport pressure altitude and temperature determine if the slats/flaps setting must be
restricted as a function of the landing weight, in order to meet the go around gradient requirement of
2.1 %.
Establish the final approach configuration with one more step of flaps. If the approach is interrupted,
retract the flaps by one step during the go-around.
In case of category II approach, JAR-OPS requires a regulatory approach climb gradient of 2.5 % to
be maintained.
Use the tables for CAT II approach to determine the maximum approach climb limiting weight
according to airport pressure altitude and temperature.
A318/A319/A320/A321 FLIGHT CREW
OPERATING MANUAL
PERFORMANCE
GO AROUND
GENERAL
A318/A319/A320/A321 FLEET PER-GOA-GEN P 3/4
FCOM 19 AUG 10
Note: 1. If circumstances dictate, landing may be made at a weight corresponding to the
maximum structural takeoff weight. (Refer to STLO-ABN-80 OVERWEIGHT LANDING).
2. When icing conditions are predicted during the flight and TAT is 10 °C or below and there
is an evidence of significant ice accretion, to take into account ice formation on the non
heated structure :
decrease the approach ‐ climb limiting weight by 7.2 %.
‐ in CONF FULL, the approach speed must not be lower than VREF +5 kt and the
landing distance must be multiplied by 1.1.
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320機組操作手冊FLIGHT CREW OPERATING MANUAL 6(81)