曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

temperatures will be required (see example on page 7-
14). You may enter the charts on any side (TAS, IAS, e. Maximum Endurance and Rate of Climb. The
mast torque, or fuel flow), move v e r t i c a l l y or maximum endurance and rate of climb lines indicate
horizontally to the gross weight, then to the other three the airspeed for minimum torque required to maintain
parameters. Maximum performance conditions are level flight for each gross weight, FAT, and pressure
determined by entering the chart where the maximum altitude. Since minimum torque will provide minimum
range or maximum endurance and rate of climb lines fuel flow, maximum flight endurance will be obtained at
intersect the appropriate gross weight, then read the airspeeds indicated.
airspeed, fuel flow, and %Q mast torque. For
conservatism, use the gross weight at the beginning of
cruise flight. For greater accuracy on long flights, it is
preferable to determine cruise information for several 7-19. CONDITIONS.
flights segments in order to allow for decreasing fuel
weights (reduced gross weight). The following The cruise charts are based upon operation at 100%
parameters contained in each chart are further engine rpm, 716 °C, and basic inlet configuration
explained as follows: (without inlet blast shield).
7-12
TM 1-1520-248-10
Figure 7-5. Cruise Chart, FAT -30 °C, Sea Level to 2000 Feet (Sheet 1 of 23)
7-13
TM 1-1520-248-10
7-14
TM 1-1520-248-10
Figure 7-5. Cruise Chart, FAT -30 °C, 4000 to 6000 Feet (Sheet 2 of 23)
7-15
TM 1-1520-248-10
7-16
TM 1-1520-248-10
Figure 7-5. Cruise Chart, FAT -30 °C, 8000 to 10000 Feet (Sheet 3 of 23)
7-17
TM 1-1520-248-10
7-18
TM 1-1520-248-10
Figure 7-5. Cruise Chart, FAT -30 °C, 12000 to 14000 Feet (Sheet 4 of 23)
7-19
TM 1-1520-248-10
Figure 7-5. Cruise Chart, FAT -15 °C, Sea Level to 2000 Feet (Sheet 5 of 23)
7-20
TM 1-1520-248-10
Figure 7-5. Cruise Chart, FAT -15 °C, 4000 to 6000 Feet (Sheet 6 of 23)
7-21
TM 1-1520-248-10
Figure 7-5. Cruise Chart, FAT -15 °C, 8000 to 10000 Feet (Sheet 7 of 23)
7-22
TM 1-1520-248-10
Figure 7-5. Cruise Chart, FAT -30 °C, 12000 to 14000 Feet (Sheet 8 of 23)
7-23
TM 1-1520-248-10
Figure 7-5. Cruise Chart, FAT 0 °C, Sea Level to 2000 Feet (Sheet 9 of 23)
7-24
TM 1-1520-248-10
Figure 7-5. Cruise Chart, FAT 0 °C, 4000 to 6000 Feet (Sheet 10 of 23)
7-25
TM 1-1520-248-10
Figure 7-5. Cruise Chart, FAT 0 °C, 8000 to 10000 Feet (Sheet 11 of 23)
7-26
TM 1-1520-248-10
Figure 7-5. Cruise Chart, FAT 0 °C, 12000 to 14000 Feet (Sheet 12 of 23)
7-27
TM 1-1520-248-10
Figure 7-5. Cruise Chart, FAT +15 °C, Sea Level to 2000 Feet (Sheet 13 of 23)
7-28
TM 1-1520-248-10
Figure 7-5. Cruise Chart, FAT +15 °C, 4000 to 6000 Feet (Sheet 14 of 23)
7-29
TM 1-1520-248-10
Figure 7-5. Cruise Chart, FAT +15 °C, 8000 to 10000 Feet (Sheet 15 of 23)
7-30
TM 1-1520-248-10
Figure 7-5. Cruise Chart, FAT +15 °C, 12000 to 14000 Feet (Sheet 16 of 23)
7-31
TM 1-1520-248-10
Figure 7-5. Cruise Chart, FAT +30 °C, Sea level to 2000 Feet (Sheet 17 of 23)
7-32
TM 1-1520-248-10
Figure 7-5. Cruise Chart, FAT +30 °C, 4000 to 6000 Feet (Sheet 18 of 23)
7-33
TM 1-1520-248-10
Figure 7-5. Cruise Chart, FAT +30 °C, 8000 to 10000 Feet (Sheet 19 of 23)
7-34
TM 1-1520-248-10
Figure 7-5. Cruise Chart, FAT +45 °C, Sea level to 2000 Feet (Sheet 20 of 23)
7-35
TM 1-1520-248-10
Figure 7-5. Cruise Chart, FAT +45 °C, 4000 to 6000 Feet (Sheet 21 of 23)
7-36
TM 1-1520-248-10
Figure 7-5. Cruise Chart, FAT +55 °C, Sea Level to 2000 Feet (Sheet 22 of 23)
7-37
TM 1-1520-248-10
Figure 7-5. Cruise Chart, FAT +55 °C, 4000 to 6000 Feet (Sheet 23 of 23)
7-38
TM 1-1520-248-10
SECTION VI. DRAG OH-58D (T703-AD-700A/250-C30R)
7-20. DESCRIPTION. 7-21. USE OF CHART.
The drag chart (fig. 7-6) shows the basic configuration
or the equivalent flat plate drag area changes for This chart i s used to adjust cruise charts f o r
additional helicopter modifications. The cruise charts appropriate torque and fuel flow due to equivalent flat
depict the basic (baseline) configuration which includes plate drag area change (ΔF). Examples of change in
the drag for the mast mounted sight, a universal torque required due to equivalent flat plate drag area
weapon pylon with ejector racks on both sides, a 7 shot change (ΔF) from primary (baseline) configuration to an
rocket pod on right side, a .50 caliber machine gun and external load configuration and increase in drag area
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：OPERATOR’S MANUAL FOR ARMY OH-58D HELICOPTER 2(67)