曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

3. Verify oil level and install dipstick and filler cap.
4. Close and secure access panel.
Approved Oils
For the first 25 hours of operation (on a new or rebuilt engine) or until
oil consumption stabilizes, use only straight mineral oil conforming to
Mil-L-6082. If engine oil must be added to the factory installed oil, add
only MIL-L-6082 straight mineral oil.
• Caution •
MIL-C-6529, Type II straight mineral oil with corrosion
preventive can cause coking with extended use and is not
recommended by Cirrus Design for break-in or post break-in
use.
After 25 hours of operation and after oil consumption has stabilized,
use only aviation lubricating oils conforming to Teledyne Continental
Motors (TCM) Specification MHS24, Lubricating Oil, Ashless
Dispersant, or TCM Specification MHS25, Synthetic Lubrication Oil.
June 2007
8-20 Information Manual
Section 8 Cirrus Design
Handling, Servicing, Maintenance SR22
Figure 8-1
Product Supplier
Aeroshell (R) W Shell Australia
Aeroshell Oil W
Aeroshell Oil W 15W-50
Anti-Wear Formulation Aeroshell 15W50
Shell Canada Ltd.
Aeroshell Oil W
Aeroshell Oil W 15W-50
Anti-Wear Formulation Aeroshell 15W50
Shell Oil Company
Aviation Oil Type A Phillips 66 Company
BP Aero Oil BP Oil Corporation
Castrolaero AD Oil Castrol Ltd. (Australia)
Chevron Aero Oil Chevron U.S.A. Inc.
Conoco Aero S Continental Oil
Delta Avoil Delta Petroleum Co.
Exxon Aviation Oil EE Exxon Company, U.S.A.
Mobil Aero Oil Mobil Oil Company
Pennzoil Aircraft Engine Oil Pennzoil Company
Quaker State AD Aviation Engine Oil Quaker State Oil & Refining Co.
Red Ram Aviation Oil 20W-50 Red Ram Ltd. (Canada)
Sinclair Avoil Sinclair Oil Company
Texaco Aircraft Engine Oil – Premium AD Texaco Inc.
Total Aero DW 15W50 Total France
Turbonycoil 3570 NYCO S.A.
Union Aircraft Engine Oil HD Union Oil Company of California
Approved Oils
June 2007
Information Manual 8-21
Cirrus Design Section 8
SR22 Handling, Servicing, Maintenance
Fuel System Servicing
After the first 25 hours of operation, then every 50-hours or as
conditions dictate, the fuel filtration screen in the gascolator must be
cleaned. After cleaning, a small amount of grease applied to the
gascolator bowl gasket will facilitate reassembly.
Fuel Requirements
Aviation grade 100 LL (blue) or 100 (green) fuel is the minimum octane
approved for use in this airplane.
• Caution •
Use of lower grades can cause serious engine damage in a
short period. The engine warranty is invalidated by the use of
lower octane fuels.
Filling Fuel Tanks
Observe all safety precautions required when handling gasoline. Fuel
fillers are located on the forward slope of the wing. Each wing holds a
maximum of 40.5 U.S. gallons. When using less than the standard
81.0 U.S. gallon capacity, fuel should be distributed equally between
each side.
• WARNING •
Have a fire extinguisher available.
Ground fuel nozzle and fuel truck to airplane exhaust pipe and
ground fuel truck or cart to suitable earth ground.
Do not fill tank within 100 feet (30.5 meters) of any energized
electrical equipment capable of producing a spark.
Permit no smoking or open flame within 100 feet (30.5 meters)
of airplane or refuel vehicle.
Do not operate radios or electrical equipment during refuel
operations. Do not operate any electrical switches.
To refuel airplane:
1. Place fire extinguisher near fuel tank being filled.
June 2007
8-22 Information Manual
Section 8 Cirrus Design
Handling, Servicing, Maintenance SR22
2. Connect ground wire from refuel nozzle to airplane exhaust, from
airplane exhaust to fuel truck or cart, and from fuel truck or cart to
a suitable earth ground.
3. Place rubber protective cover over wing around fuel filler.
• Note •
Do not permit fuel nozzle to come in contact with bottom of
fuel tanks. Keep fuel tanks at least half full at all times to
minimize condensation and moisture accumulation in tanks. In
extremely humid areas, the fuel supply should be checked
frequently and drained of condensation to prevent possible
distribution problems.
4. Remove fuel filler cap and fuel airplane to desired level.
• Note •
If fuel is going to be added to only one tank, the tank being
serviced should be filled to the same level as the opposite
tank. This will aid in keeping fuel loads balanced.
5. Remove nozzle, install filler cap, and remove protective cover.
6. Repeat refuel procedure for opposite wing.
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：AIRPLANE INFORMATION MANUAL for the CIRRUS DESIGN SR22(95)