5)  Press the small right knob to remove the cursor.

to tURN the data fieLdS off aNd
diSpLay a fULL SCReeN map 
1)  With the Map Page displayed, press the MENU Key to display an options menu. 
2)  Turn the large right knob to highlight ‘Data Fields Off?’ and press the ENT Key. 

3)  To re-display the data fields, follow steps 1 and 2, but instead select ‘Data Fields On?’ from the options menu.
to QUiCKLy deCLUtteR the map diSpLay
Press the CLR Key momentarily (as often as needed) to select the desired amount of map detail.

to iNhibit teRRaiN:
1)  Select the TERRAIN Page and press the MENU Key. ‘Inhibit Terrain?’ is selected by default.

Annunciator Field

NOTE: Inhibit modedeactivatesTERRAINalerting when deemed unnecessary by the pilot. Flying VFR into an area where unique terrain exists could cause the system to annunciate nuisance alerts. Pilots should use discretion when inhibiting the TERRAIN system and always remember to enable the system when appropriate.

NavCom paGe
The NAVCOM Page provides a list of the airport communication and navigation frequencies at the departure, enroute, and arrival airports.
Assigned Frequency and Departure, Enroute, or Usage Information (When
Arrival Airport Applicable)

to SeLeCt a fReQUeNCy LiSt foR a

depaRtURe, eNRoUte, oR aRRivaL aiRpoRt 
1)  Press the small right knob to activate the cursor. 
2)  Turn the large right knob to place the cursor on the airport identifier field (top line on the NAVCOM Page). 
3)  Turn the small right knob to select the desired airport and press the ENT Key. 

to SCRoLL thRoUGh the LiSt of

fReQUeNCieS 
1)  Activate the cursor, if not already active, by 
pressing the small right knob. 
2)  Turn the large right knob to move the cursor 
through the list of frequencies.  If there are 
more frequencies in the list that can be 
displayed on the screen, a scroll bar along the 
right-hand side of the screen indicates which 
part of the list is currently being displayed. 

to aUto-tUNe a fReQUeNCy fRom the NavCom paGe
1)  Highlight the desired frequency by scrolling through the list of frequencies, as described in the preceding procedure.
2)  To place a frequency in the standby field of the COM or VLOC Window, highlight the desired frequency and press the ENT Key.

bottom Row aNNUNCiatoRS aNd meSSaGeS
TERRAIN Annunciator: CDI/RAIM Mode:TERRAIN, TERRAIN Approach, Enroute, (Flashing),TER FAIL, TER INHB, Oceanic Terminal, or TER N/A (see Pilot’s Guide for or ‘0.30’ (for VLOC
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：GNS 430/430A Quick Reference 快速參考(7)