V = Vertical G load, S = Side G load, A = fore and aft G load
1.3  Loads shown are allowable limit loads except where otherwise specified.
1.2  No deflection permitted in engine or in shipping or ground handling locations when installing into handling fixtures or shipping containers.
1.1  Drawing interpretations per Specification PWA 360.
Legend: H = Horizontal load V = Vertical load A = Axial load MH = Horizontal twisting moment MV = Moment about vertical line due to axial load RH = Reaction load at flanges N.-m. = Newton-meter
5-4-1

DESIGN LOADS Page 5-12 Apr 11/2002
D623N005

757

PW2000 SERIES ENGINE GROUND HANDLING DOCUMENT
Figure 5-8 PRIMARY REAR GROUND HANDLING -SIDE PICKUP

5-4-1

DESIGN LOADS
Page 5-13 Apr 11/2002 D623N005
 

757

PW2000 SERIES ENGINE GROUND HANDLING DOCUMENT
Figure 5-9 SECONDARY REAR GROUND HANDLING -TOP PICKUP

5-4-1

DESIGN LOADS Page 5-14 Apr 11/2002
D623N005

757

PW2000 SERIES ENGINE GROUND HANDLING DOCUMENT
Figure 5-10 FORWARD ADAPTER CONCEPT -PW2000 SERIES

5-4-1

DESIGN LOADS
Page 5-15 Apr 11/2002 D623N005
 

DESIGN  AXIAL  LATERAL  VERTICAL 
3.0  2.0  5.0 
PROOF  1 2 3 4 5 6 7 8  +3.0 -3.0 +1.5 +1.5  +1.5 -1.5 +1.5 -1.5  -3.0 +1.5 -3.0 +1.5 

Design and proof loads for the engine stand are shown in Figure 5-11. Any element of the transport system to be used in hoisting or lifting the complete engine powerplant will be designed to a safety factor of not less than five for the total weight of the maximum EBU configuration.
The stand incorporates a shock attenuation arrangement which provides a suspended system natural frequency of 7-10 Hz. Sufficient sway space is allowed to permit proper functioning of the shock mounts during truck transport.
5-4-1

DESIGN LOADS
Page 5-16 Apr 11/2002 D623N005
 

5.5 GROUND HANDLING
5.5.1 Ground Handling For Engine Transport
The engine ground handling stand includes provisions for fork lifting from either side. The stand is towable to 5 mph (8 km/h) on paved, smooth surfaces and incorporates a towbar usable at either end. All of the requirements for the engine transportation stand except special shock and vibration protection are incorporated in the engine ground handling stand. Pneumatic tires may be used for ground transport instead of casters.
5-5-1

GROUND HANDLING
Page 5-17 Apr 11/2002 D623N005
 
THIS PAGE INTENTIONALLY LEFT BLANK

6 TEST CELL
6.1 GENERAL
6.1.1 Engine Test Cell Overview
Engine Testing is an integral part of a commercial air carriers engine maintenance operation and is performed in an engine test cell to verify performance of an engine. The testing may be carried out after repairs in the shop are accomplished or prior to a shop visit to verify squawks from flight operations or as a diagnostic tool to establish required repairs.
　
中國航空網(wǎng) m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：757 PW2000 Series Engine Ground Handling Document 發(fā)動機地面處理文件(20)