曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

PRECOOLER
The precooler is part of the pneumatic system. It is located in the outboard side of the nacelle support strut. Precooler removal involves loosening and removing two sections of duct and the precooler mounting bolts. The handling equipment (Figure 4-3) consists of handles that mount in place of the ducts, using the duct V-band clamps, and a piece of heavy-duty carpet to protect underlying components.
BOEING GSE IDENTIFICATION
Listed below is ground support equipment used to install and remove major PW2000 series components.
TOOL NOMENCLATURE  GSE DRAWING NUMBER 
INTEGRATED DRIVE GENERATOR, INSTL/REMOVAL FIXTURE PRECOOLER INSTALLATION/REMOVAL EQUIPMENT ENGINE ACCESSORY LIFT FIXTURE  A71013 A36001 A71015 

4-1-1
GENERAL
Page 4-1 Apr 11/2002 D623N005
 

757

PW2000 SERIES ENGINE GROUND HANDLING DOCUMENT

4-1-1

GENERAL
Page 4-2 Apr 11/2002 D623N005
 

757
PW2000 SERIES ENGINE GROUND HANDLING DOCUMENT
Figure 4-2 INTEGRATED DRIVE GENERATOR INSTALLATION/REMOVAL EQUIPMENT

4-1-1

GENERAL
Page 4-3 Apr 11/2002 D623N005
 

757

PW2000 SERIES ENGINE GROUND HANDLING DOCUMENT

4-1-1

GENERAL Page 4-4 Apr 11/2002
D623N005

5 ENGINE TRANSPORTATION
5.1 GENERAL
5.1.1 Engine Transportation Overview
The PW2000 Series engine can be shipped via air or truck. Truck transport on air suspension (air ride) tractor and trailers is mandatory. Transportation stands are built with retractable casters to enable local ground mobility at speeds limited to 2-5 mph (3.2-8 km per hour). A split-engine transport system can be designed and fabricated which allows engine transport in standard body cargo airplanes and the lower cargo compartment of wide body airplanes.
The primary ground handling points used to support the engine during transportation are defined on installation drawings available from Pratt & Whitney Aircraft.
5-1-1

GENERAL
Page 5-1 Apr 11/2002 D623N005
 

5.2 SHIPPING METHODS
5.2.1 Shipping Methods Overview
The potential for either full engine or split-engine air transport has been provided in the design of the PW2000 series engine. The major assemblies, with the exception of the fan cases, may be shipped in the lower cargo compartment of many narrow body passenger airplanes. All of the major assemblies will fit in wide body passenger airplane cargo compartments.
Figure 5-1 identifies airplanes with the capability for engine transport. This is based upon airplane door and compartment measurements. Further assessments must be made regarding floor loading, etc. when selecting a particular airplane for engine transport. Figure 5-1 shows a sampling of airplanes that could potentially be used for engine transport.
Engine transport system specifications have been developed to define the requirements for the design and fabrication of engine transport equipment.
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：757 PW2000 Series Engine Ground Handling Document 發動機地面處理文件(17)